Lofrans SX4 handleiding
Handleiding
Je bekijkt pagina 9 van 22
9
www.lofrans.com
Do not carry out the anchor recovery operation by relying only on the onboard batteries. Start the motor of the
boat (or the generator) to obtain the necessary electromotive force.
UK
The hydraulic magnetic circuit breaker does not protect against an excessive increase in the motor temperature due to a
prolonged operation of the anchor windlass. Therefore, give the motor the necessary time to cool, to avoid possible damages
to the motor thereof.
5.2 Weighing the anchor
1. Make sure that the hydraulic magnetic circuit breaker is activated.
2. Make sure that the clutch is well tightened and the brake is disengaged. Take out the manoeuvre handle from the drum or gipsy.
3. Disengage the chain stopper and safety stops.
4. Press the UP button from the control at your disposal until the anchor reaches its position inside the bow roller.
5. Deactivate the hydraulic magnetic circuit breaker.
6. Fix the chain with the chain stopper. In this way a potential damage of the anchor windlass will be avoided as well as unexpected
chain releases.
To safeguard the anchor windlass, the hydraulic magnetic circuit breaker is sized so that it comes into action when the anchor windlass is
subjected to higher loads than those for which it has been designed. Should it get released owing to an overload reactivate it again and
wait some minutes before operating it; waiting for the operation after an overload is necessary to allow the circuits to cool and recover
their functionalities.
UP
5.3 Use of the warping drum
1. Tighten the brake and make sure that the anchor is appropriately blocked.
2. Insert the manoeuvre handle into the drum and disengage the clutch by turning it clockwise. This operation will make the drum
independent of the gipsy.
3. Turn clockwise around the drum with three laps of rope.
4. By keeping the end of the rope, press the UP button and carry out the mooring manoeuvre.
5. Once the manoeuvre is ended, remove the rope from the drum and fasten it to a bollard.
6. Deactivate the safety switch.
The warping drum can be used regardless of the gipsy, to help the mooring manoeuvres.
Always remove the manoeuvre handle when not in use.
Lofrans'
Bekijk gratis de handleiding van Lofrans SX4, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lofrans |
| Model | SX4 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3008 MB |
