Lofrans SX2 handleiding
Handleiding
Je bekijkt pagina 9 van 20
9
www.lofrans.com
UP
By disengaging completely the clutch, the anchor will be lowered at high speed. Consequently, the fast passage of the
chain into the hood and bow roller could damage them. It is recommended always to check the speed.
Make sure the anchor windlass is not powered before carrying out manual interventions.
5.1.2 Lowering the anchor by gravity
1. Make sure that the clutch is tightened and then disengage the chain stopper or safety stops.
2. Disengage the clutch gradually through the manoeuvre handle. Note: to adjust the descent speed of the chain act, through the
handle, on the clutch. By turning it clockwise, the braking speed of the chain will increase (until complete stop), while by turning it
anticlockwise, braking will be reduced.
3. Fix the chain to a strong point.
UK
Do not carry out the anchor recovery operation by relying only on the onboard batteries. Start the motor of the boat (or the
generator) to obtain the necessary electromotive force.
The hydraulic magnetic circuit breaker does not protect against an excessive increase in the motor temperature due to a
prolonged operation of the anchor windlass. Therefore, give the motor the necessary time to cool, to avoid possible damages
to the motor thereof.
5.2 Weighing the anchor
1. Make sure that the hydraulic magnetic circuit breaker is activated.
2. Make sure that the clutch is well tightened. Take out the manoeuvre handle from the drum or gipsy.
3. Disengage the chain stopper and safety stops.
4. Press the UP button from the control at your disposal until the anchor reaches its position inside the bow roller.
5. Deactivate the hydraulic magnetic circuit breaker.
6. Fix the chain with the chain stopper. In this way a potential damage of the anchor windlass will be avoided as well as unexpected
chain releases.
To safeguard the anchor windlass, the hydraulic magnetic circuit breaker is sized so that it comes into action when the anchor windlass is
subjected to higher loads than those for which it has been designed. Should it get released owing to an overload reactivate it again and
wait some minutes before operating it; waiting for the operation after an overload is necessary to allow the circuits to cool and recover
their functionalities.
Lofrans'
Bekijk gratis de handleiding van Lofrans SX2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lofrans |
| Model | SX2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3068 MB |
