Lofrans Gecko handleiding
Handleiding
Je bekijkt pagina 5 van 27
2. SAFETY INFORMATION
Safety standards and certifying bodies require peremptorily that, during the standing of the anchor, the load must be
held by a chain stopper or a high resistance fixing point.
The user is responsible for guaranteeing that during navigation the anchor is properly stowed and fixed. This
precaution is more important when the navigation speed is higher and sea conditions are worse. Indeed, an anchor
paid out by mistake during navigation can have very serious effects. Considering its position and not always frequent
use, the anchor windlass is particularly exposed to oxidation and corrosion risk; therefore, it is necessary to arrange a
constant inspection of its parts and a due maintenance.
Make sure to have read and understood every part of this manual before proceeding with installation and use. Only
persons who know how to operate should be authorized to use the anchor windlass. Should there be doubts on its
installation or use, refer always to a skilled consultant.
Anchor windlasses used in an inappropriate way can cause damages to persons and/or things.
Pay the utmost attention during the use of powerful equipment.
Do not put your hands near the windlass when there is power on the unit.
Even the most careful use can be a source of damages, even serious.
Lofrans' products are supplied exclusively for recreational nautical use. Lofrans' declines all responsibility for
improper uses.
The windlass is not designed for loads that might occur in extreme weather conditions. Lofrans' is not
responsible for failures during use under such conditions.
Pay the utmost attention so that arms, legs, fingers, hair, and clothes do not get entangled in the gipsy.
Check that there are no swimmers nearby while using the windlass.
When the windlass is not used, the anchor must always be fixed to a solid point in order to avoid damages.
The anchor windlass must never be used as mooring point. The load must be always fixed to a solid point.
The anchor windlass must not be used for functions other than releasing or weighing the anchor.
The system must always be protected by a suitable circuit breaker, according to the instructions of chapter 4.
Electrical System of the current manual.
Always disconnect the circuit through the circuit breaker when the anchor windlass is not in use.
5
Lofrans'
Bekijk gratis de handleiding van Lofrans Gecko, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lofrans |
| Model | Gecko |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6721 MB |
