Livoo DOH143 handleiding
Handleiding
Je bekijkt pagina 15 van 52
www.livoo.fr
7
Brush compartment cover
Before use, assembling
Assemble the handle by clipping it on; when you want to remove it, use a screwdriver to press lightly into
the rear hole (figure 2).
Install the rotating brush: to unlock the brush compartment cover, lower the locking catch, insert the
rotating brush, aligning it with the drive shaft, then lower it and close the cover (figure 5).
Open the screw cap and fill the tank with clean water and a non-foaming cleaning solution (figure 3).
Replace the clean water tank. Make sure the dirty water tank is securely in place (figure 4).
Use of the device
Plug in the unit, press the on/off button. Suction starts. Press and hold the spray trigger to spray liquid.
Note:
When the wastewater tank reaches the
maximum water level, turn off the power and unplug it. Turn
off your appliance and unplug it. Drain the clean water and waste water, and clean the waste water
tank.
After using the device, the textile will still be humid or a little wet. To avoid any unpleasant odour, you can
dry the textile with an hair dryer or expose it to the sun.
For stubborn dirt, apply the water/detergent mixture on the surface to be cleaned and rub the
dirt with the
brush.
Example of recommended detergent:
Strong alkaline ionized water, water and 5 to 10 g baking soda, 3%
white vinegar.
Example of not appropriate detergent :
Neutral detergent for kitchen use, strongly alkaline detergent,
strongly acidic detergent.
When using a detergent with a lot of foam, the foam might get inside the cleaner.
Note: When using detergent, first test it on the edge of the carpet fabric being cleaned to make sure
that
there is no discoloration.
Cleaning and maintenance
Switch off the device and unplug it
Cleaning of the clean water tank
(
Figure 3):
Take out the clean water tank. Unscrew the cap at the bottom of the tank and pour away the remaining
water. Replace the tank and then turn on the power again.
Press the watering button to remove the remaining water. Tilt slightly the machine if necessary.
Cleaning of the wastewater tank( Figure 4):
When the wastewater tank reaches the maximum water level, turn off the device and empty the tank.
If you continue to use the device after the sewage exceeds the maximum water level, the floating ball will
move up and the suction will stop.
Hold the handle of the dirty water tank with your hand, press the latch with your thumb and pull gently to
remove the dirty water tank.
Clean the dirty water tank and filter ( figure 6) after each use to prevent the formation of bacteria and
odours, dry them well and then replace them. Lock the tank.
Cleaning accessories(figure 5) :
After each use, dismantle the brush compartment cover as described above, remove the brush and
clean it.Then replace the cover and brush.
Self-cleaning:
If you prefer to avoid disassembling the brush compartment, put the appliance into the
storage base, press the power button, turn on the appliance, press the spray button (do not let go), and
Bekijk gratis de handleiding van Livoo DOH143, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Livoo |
| Model | DOH143 |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 4643 MB |
