Livn Basic 10 handleiding
Handleiding
Je bekijkt pagina 3 van 50
• The rating of the heating foil must comply with the rating of the thermostat, the circuit breaker
and if needed the contactor. Good wiring practice must be observed. Installation must comply
with current building and wiring regulations. Connection cables must not come in contact with
the heating foil. The heating foil must be installed together with an RCD with a maximum
breaking current of 30 mA.
• Tip: after installation measure the resistances of all heating films installed by a resistance meter.
SECTION 1: INSTALLATION TOOLS AND MATERIAL
We highly appreciate you purchasing Livn infrared floor heating. We hope this installation guidance
helps the safe installation and solves any problems during this process.
1.1 Tools
Name
Standard
Usage
Electric tester*
4.2 V to 500 V AC
50 ohm to 42 M-ohm
Voltage measurement
Resistance measurement
Electric leakage tester*
Electric leakage measurement
Infrared thermometer*
-30 ~ 300 °C
Heating film temperature measurement
Terminal / wire presser
0.75 ~ 5.5 mm
Eyelet terminal combination / Electric
wire connection
Eyelet punch
To make hole on heating film for eyelet
terminal
Stripper*
0.75 ~ 5.5 mm
Electric wire connection
Scissors*
Middle size
Heating film cutting
Cutting knife*
Middle size
Insulation pad cutting
Calculator*
Electricity consumption calculation
Driver*
Middle size (+/-)
Inlet plug, thermostat combination
Electric motion drill*
220 V using product
Thermostat fixating
Measure tapeline*
7.5 m length
To measure installation space
Gloves
*Not included
Bekijk gratis de handleiding van Livn Basic 10, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Livn |
| Model | Basic 10 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 15727 MB |
