Livarno Lux IAN 73010 handleiding
Handleiding
Je bekijkt pagina 28 van 40
28 GB/MT
(ø 3.7 x 28 mm). To do so, use the pre-finished
mounting holes (see Fig. E).
After mounting, check that the solar cell is fitted
securely.
Note: After mounting, orient the solar cell by
tilting it. The solar cell is fitted with a joint which
locks every 18° to permit orientation.
Preparing the product for use
Switching the motion detector
on and off
Slide the AUTO / OFF switch
4
into the AUTO
position to switch on the motion detector
6
.
Slide the AUTO / OFF switch into the OFF posi-
tion to switch off the motion detector.
Setting the lighting duration
Turn the rotary control TIME
10
on the bottom
of the motion detector
6
clockwise to increase
the duration of the illumination. The lighting
duration can be adjusted within a time window
of approx. 10–60seconds.
Adjusting the sensitivity of
the sensor
Turn the rotary control SENS
9
on the bottom
of the motion detector
6
clockwise to in-
crease the sensitivity of the sensor.
Note: The motion detector responds to heat
radiation. When outdoor temperatures are low,
it is more sensitive to body heat than when out-
door temperatures are warm. Be sure to regu-
late the sensitivity of the sensor over the course
of the year.
Setting the daylight level
Turn the rotary control LUX
8
on the bottom of
the motion detector
6
clockwise to increase
the daylight level. In position , the motion
detector only responds at pitch-black night
(approx. 50 lx). In position
, the motion
detector also responds at daylight levels, as
long as about 20,000lx are not exceeded.
Orientating the motion
detector
Loosen the fastening screws
5
of the motion
detector
6
.
Turn the rotary control LUX
8
to position .
Orient the motion detector into the central
region of the desired coverage area.
Move about through the coverage area until
you are satisfied with the response characteris-
tics of the motion detector. To find the proper
orientation, change the position of the rotary
control SENS
9
or the orientation of the
motion detector.
Re-tighten the fastening screws to fix the adjust-
ment.
Turn the rotary control LUX to the desired posi-
tion. These can be determined during the dawn
or twilight hours during which the spotlight
7
should respond. Slowly turn the rotary control
LUX clockwise until it reacts to movement within
the coverage area.
Maintaining the device
Replacing the
rechargeable battery
Note: This work step requires a Phillips screwdriver
and a flat-nose pliers.
Note: Suitable batteries that comply with the
specifications listed under “Technical data” are
available in specialist shops.
Replace the battery
20
if after a certain
amount of time, the light duration diminishes
noticeably despite good exposure to sunlight.
Only use rechargeable batteries of the right
Bekijk gratis de handleiding van Livarno Lux IAN 73010, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Livarno Lux |
| Model | IAN 73010 |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 3935 MB |
