Livarno Lux IAN 283331 handleiding
Handleiding
Je bekijkt pagina 14 van 49
14 GB/IE
Safety / Initial use Care and cleaning / Disposal / Warranty and Service
Remain alert at all times and always watch what
you are doing. Always proceed with caution
and do not assemble the lamp if you cannot
concentrate or feel unwell.
In order to disconnect the lamp completely from
the power supply, the mains plug
5
must be
removed from the socket.
Initial use
Assembling the light
Model no.: 14121106L / 14121209L
Connect the sections of the tube
3
and screw
in place.
Note: Be sure to screw in the tubes
3
as far
as possible so that the light is stable.
Repeat this process with all sections of the
tube
3
.
Assemble the lamp head by screwing the tubes
3
one after the other onto the screw thread
2
.
Note: Be sure to screw in the tubes
3
as far
as possible so that the light is stable.
Use a clean, lint-free cloth to insert the bulb
1
.
S
crew the bulb
1
clockwise into the lamp socket.
Plug the mains plug
5
into a properly in-
stalled socket.
Verify it is seated correctly.
Model no.: 14121305L
Note: Remove the transport locks from the tubes
3
.
Please ensure that you pull the cable during assembly
slowly through the tube
3
.
Connect the individual sections of tube
3
to
one another and screw into place in an anti-
clockwise direction. Be careful not to damage
the cable in the inside of the lamp.
Screw the tube
3
clockwise onto the base
6
.
Remove the lamp ring
9
from the lamp
socket
11
.
Place the lamp shade
10
onto the lamp socket
11
and screw it tightly using the lamp ring
9
.
Use a clean, lint-free cloth to insert the bulb
1
.
Screw the bulb
1
clockwise into the lamp
socket
11
.
Plug the mains plug
5
into a properly installed
socket.
Verify it is seated correctly.
Your light is now ready to use.
Switching the light on / off
Use the foot switch
4
to turn the LED light on
and off.
Adjusting the lamp
CAUTION! RISK OF BURNS DUE TO
HOT SURFACES! Allow the lamp to cool
down completely.
Model 14121305L: Bring the lamp arm into
the desired position
8
. If the lamp arm
8
changes position, retighten the locating screw
7
.
All models: The lamp head for all models can
be moved up or down.
Changing the bulb
DANGER OF ELECTRIC
SHOCK! First unplug the mains plug
5
from the
socket.
CAUTION! RISK OF BURNS DUE TO HOT
S
URFACES! Allow the light to cool down comple
tely.
Only replace the lamp after it has completely
cooled off.
Use a clean, lint-free cloth when replacing the
bulb
1
.
Twist the defective bulb
1
anti-clockwise out
of the bulb socket.
Only use LED bulbs with a maximum output of
7 W and E27 base.
Insert the new bulb
1
into the bulb socket and
turn it clockwise to tighten it. Ensure that it is
positioned correctly.
Plug the mains plug
5
into the socket again.
Bekijk gratis de handleiding van Livarno Lux IAN 283331, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Livarno Lux |
| Model | IAN 283331 |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 4477 MB |
