Livarno Lux IAN 280204 handleiding
Handleiding
Je bekijkt pagina 16 van 51
14 GB/IE
... / Maintenance ... / Disposal / Declaration of ... / Warranty / Service centre Preparation / Prior to installation / Initial use
Preparation
Required tools and material
The tools and materials specified are not included.
This information and these values are non-binding
and are only provided as a reference. The nature
of the material is determined by the individual local
conditions.
- Pencil / marking tool
- Voltage tester
- Screwdriver
- Electric drill
- Bit (ø approx. 0.6 cm)
- Side cutting pliers
- Ladder
Prior to installation
Important: The electrical connection must be
established by a qualified electrician. This person
must be familiar with the properties of the light and
the connection regulations.
Familiarise yourself with all the instructions and
diagrams in this manual, as well as with the
light itself, before you install it.
Make careful preparations for mounting and
allow yourself adequate time. Organise all
parts and any necessary additional tools or
materials before starting so they are easy to
reach.
Always be attentive! Always pay attention to
what you are doing and proceed with caution
at all times. Never install the light if you are
having difficulty concentrating or do not feel
well.
Before installation ensure that the circuit to
which the light will be connected is not ener-
gised. To do so, remove the fuse or switch off
the circuit breaker in the fuse box (position 0).
Verify that the components are not energised
using a voltage tester.
Ensure that you do not damage any electrical
cables, gas or water pipes when you drill into
the wall.
Please refer to the instructions for use for your
power drill.
Initial use
Installing the light
DANGER OF ELECTRIC
SHOCK!
Remove the fuse or switch off the circuit breaker
(0 setting) in the fuse box prior to installation
(see Fig. A).
Install the light as shown in Figure B . While
doing so, ensure that you follow the order of
the individual steps as stated in these instruc-
tions.
Reinstall the fuse or switch on the circuit breaker
in the fuse box (I setting) (see Fig. C).
Dimming the light
You have the option of dimming the light using
a button
10
.
Press and hold the button
10
to reduce bright-
ness.
Press and hold the button
10
again to increase
brightness.
If you switch the light on or off using the wall
switch, it will be at 100% brightness.
Adjusting the light
If the pendant does not hang down straight,
you can adjust it at the connection housing
5
.
Press the height adjustment
9
on the end of
the cable back into the connection housing
5
.
Push the cable into the connection housing
5
to shorten it (max. 40 cm).
Pull the cable out of the connection housing
5
to extend it.
Bekijk gratis de handleiding van Livarno Lux IAN 280204, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Livarno Lux |
| Model | IAN 280204 |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 4543 MB |
