Livarno Lux IAN 279823 handleiding
Handleiding
Je bekijkt pagina 12 van 18
11 GB/IE/NI
product. The surface must be
clean, free from grease and dry.
The adhesion of the double-sided
adhesive strip
5
,
10
may other-
wise be limited.
Note: Before use, check on a hid-
den area of the surface, whether
the adhesive can cause damage.
Peel the protective film off the
adhesive strip on the back of
the LED strip
2
and secure
the LED strip in the desired
location.
Secure the LED driver
4
with
the included double-sided
adhesive strip
5
or the in-
cluded screws
8
.
Connect the power supply
3
with the LED driver.
Then connect the LED driver to
the LED strip.
Note: When connecting the
LED driver with the LED strip,
be sure to match up the VGGD
mark on the LED driver and
the VCC-GND-GND-DI mark
on the LED strip.
Be sure the power supply is
always accessible.
Plug the power supply into
the socket before switching
the product on.
Connecting 2 LED
strips (see Fig. B)
Note: Up to two 5 m LED strips
may be connected using the
eight-pin plug
9
and operated
with the LED driver
4
and a
power supply
3
. Otherwise
there is a risk of overloading the
components and fire!
Note: When connecting the two
ends of the LED strip using an
eight-pin plug, be sure to match
up the VCC-GND-GND-D0 and
VCC-GND-GND-DI marks at the
ends of the LED strips.
After connecting the two LED
strips, only the first LED strip
is lighting once connected to
electricity supply.
To light up the second LED strip,
press the
IC Set
button and then
press the
button to switch
groups of three lights on,
starting from the beginning
of the second LED strip.
Bekijk gratis de handleiding van Livarno Lux IAN 279823, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Livarno Lux |
| Model | IAN 279823 |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 1182 MB |
