Handleiding
Je bekijkt pagina 8 van 112
‑ 8 ‑EN
The receiver operates on baery and mains power. To connuously monitor your child,
use both the baery and mains power at the same me. With the baery alone, the
receiver can only operate wirelessly for a limited me.
Powering up and switching on the electronic nanny transmier (g.2 3)
1. Connect the power cord to the receiver and the other end to the power source.
2. The indicator light will illuminate red.
3. Press and hold the power buon to switch on the transmier.
4.
The device will beep and the indicator light will alternately ash red and green,
indicang that the device has entered pairing mode.
5. To switch o the transmier, press and hold the power buon.
OPERATION OF THE ELECTRONIC NANNY
Pairing the device
When the receiver and the electronic nanny transmier are switched on, they will be
automacally paired and the device will nofy this with an audible signal.
If the device is not paired for 10 minutes, it will automacally exit pairing mode and
switch o.
Set-up and operaon
Place the transmier anywhere (e.g. on a table) and point it in the direcon you want to
monitor. When the transmier detects sound, a message will be shown on the receiver.
NOTE
Do not place the transmier or cords in or within reach of the baby’s cot (min. 1 metre
distance), as there is a risk of injuring or strangling the child!
In case of sound interference, place the devices in a dierent locaon and make sure
they are not near other electrical devices.
Range
The operang range of the electronic nanny is up to 400 metres outdoors or 70 metres
indoors. The operang range may vary depending on ambient condions and other
Bekijk gratis de handleiding van Lionelo Babyline 2.3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lionelo |
| Model | Babyline 2.3 |
| Categorie | Babyfoon |
| Taal | Nederlands |
| Grootte | 9640 MB |
