Handleiding
Je bekijkt pagina 6 van 96
‑ 6 ‑EN
INSTRUCTIONS FOR USE:
Note
Make sure the devices are placed on a at and stable surface.
Powering up and switching on the electronic nanny receiver (g.1)
NOTE: It is recommended to fully charge the device before rst use
1.
Insert the enclosed baeries into the baery compartment of the receiver (12, g.1)
then connect the plug of the cable to the device and the other end to the power
source. Remember the correct polarity when inserng the baeries.
2. Press and hold the power buon (5, g.1) to switch on the receiver. The device
will beep and the indicator light will ash, indicang that the device has entered
pairing mode.
3. To switch o the receiver, press and hold the power buon.
The receiver operates on baery and mains power. To connuously monitor your child,
use both the baery and mains power at the same me. With the baery alone, the
receiver can only operate wirelessly for a limited me.
Powering up and switching on the electronic nanny transmier (g.2)
1. Connect the power cord to the receiver and the other end to the power source.
2. The indicator light will illuminate red.
3. Press and hold the power buon to switch on the transmier.
4.
The device will beep and the indicator light will alternately ash red and green,
indicang that the device has entered pairing mode.
5. To switch o the transmier, press and hold the power buon.
OPERATION OF THE ELECTRONIC NANNY
Pairing the device
When the receiver and the electronic nanny transmier are switched on, they will be
Bekijk gratis de handleiding van Lionelo Babyline 2.2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lionelo |
| Model | Babyline 2.2 |
| Categorie | Babyfoon |
| Taal | Nederlands |
| Grootte | 8120 MB |
