Linsar 24LED3000 handleiding

39 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 18 van 39
English - 17 -
ElectronicProgrammeGuide(EPG)
Some, but not all channels send information about the
current and next programmes. Press the button
to view the EPG menu.
Up/Down/Left/Right: Navigate EPG.
OK: Displays programme options.
: Displays, in detail, information on the programme
selected.
GREEN: Switches to List Schedule EPG.
YELLOW: Switches to Timeline Schedule EPG.
BLUE: Displays ltering options.
(RECORD): The TV will start to record the selected
progamme. You can press again to stop the recording.
IMPORTANT: To record a programme, you should rst connect
a USB disk to your TV while the TV is switched off. You should
then switch on the TV to enable the recording feature. Otherwise,
the recording feature will not be available.
Note: Switching to a different broadcast or source is not available
during a recording.
ProgrammeOptions
In the EPG menu, press the OK button to enter the
Event Options menu.
SelectChannel
In the EPG menu, using this option, you can switch to
the selected channel.
Record/DeleteRecordTimer
After you have selected a programme in the EPG menu,
press the OK button and and the Options screen will be
displayed. Select the “Record” option and press the OK
button. After this operation, a recording will be scheduled
for the selected programme.
To cancel an already set recording, highlight that
programme and press the OK button and select the
option “Delete Rec. Timer”. The recording will be
cancelled.
SetTimer/DeleteTimer
After you have selected a programme in the EPG menu,
press the OK button and and the Options screen will
be displayed. Select the “SetTimeronEvent” option
and press the OK button. You can set a timer for future
programmes. To cancel an already set timer, highlight
that programme and press the OK button. Then select
DeleteTimer” option. The timer will be cancelled.
Note: It is not possible to record two channels at the same time.
RecordingaProgramme
IMPORTANT: When using a new USB hard disk drive, it is
recommended that you rst format the disk using your TV’s
“Format Disk” option.
To record a programme, you should rst connect a USB
disk to your TV while the TV is switched off. You should
then switch on the TV to enable the recording feature.
To use the recording function, you need to connect a
USB disk or an external hard disk drive to the TV and
the connected USB disk should have at least 1 GB
capacity and should have 2.0 speed compatibility. If the
connected USB device does not support 2.0 speed, an
error message will be displayed.
Note: Recorded programmes are saved into the connected
USB disk. If desired, you can store/copy recordings onto a
computer; however, these les will not be available to be played
on a computer. You can play the recordings only via your TV.
Note: Lip Sync delay may occur during the timeshifting. Radio
record is not supported. The TV can record programmes
up to ten hours.
Dependent on the size of the USB, compatible devices
only recorded programmes are split into 4GB partitions.
Recorded programmes are split into 4GB partitions.
If the writing speed of the connected USB disk is not
sufcient, the recording may fail and the timeshifting
feaute may not be available.
Recordings of HD programmes can occupy more space
on the USB disk compared to SD programmes. For this
reason it is recommended to use USB hard disk drive
to record HD programmes.
Do not plug out the USB/HDD during a recording. This
may harm the connected USB/HDD. Strongly advised
to have an external power source when using a HDD.
Multipartiton support is available. A maximum of two
different partitions are supported. If the disk has more
than two partitions, a crash may occur. The rst partition
of the USB disk is used for PVR ready features. It also
must be formatted as the primary partition to be used
for PVR ready features.
Some stream packets may not be recorded because
of signal problems, so sometimes the video may freeze
during playback.
Record, Play, Pause, Display (for PlayListDialog) keys
can not be used when teletext is ON. If a recording starts

Bekijk gratis de handleiding van Linsar 24LED3000, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkLinsar
Model24LED3000
CategorieTelevisie
TaalNederlands
Grootte6060 MB