Handleiding
Je bekijkt pagina 17 van 57
Part Number 20000095 Rev J 5/15 17
Section 2 Installation
5. Rotate the finger brackets until the notches in the
brackets sit on the retaining pins.
Notch
Pin
6. Assemble fingers as shown in steps 7 and 8.
Finger
Housing
Finger
Cover
Number Stamped in Panel
7. Insert columnating plate so the step goes under the lip
of the finger housing and the plate lies flush with the
housing side edge.
8. Install cover by sliding it on the small end.
9. Insert assembled finger through door opening starting
with lower left. NOTE: The customer MUST tell you
what position to place the assembled finger in, for their
application.
10. Install finger in the oven by sliding it over the plenum
flange and setting the front bracket. BE SURE THAT THE
FINGER SITS SQUARELY OVER THE PLENUM FLANGES
AND THE HOLES POINT IN THE PROPER DIRECTION. Top
fingers point down, bottom fingers point up.
11. Repeat step 10 until all ten (10) fingers are installed.
Install conveyor and crumb pans before operation. See
“Weekling Cleaning” in Section 4 for instructions.
Bekijk gratis de handleiding van Lincoln Impinger FASTBAKE, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lincoln |
| Model | Impinger FASTBAKE |
| Categorie | Oven |
| Taal | Nederlands |
| Grootte | 6285 MB |
