Lincoln Electric Fume Extraction Arms handleiding

Niet gecategoriseerd

Lincoln Electric

50 pagina's

PDF beschikbaar

Handleiding

A-12

INSTALLATIONFUME EXTRACTION ARMS

Electrical Connection for ARC SENSOR/LAMP KIT

The K2633-6 or K2633-8 Flexible 10 FT. or 13 FT. Automatic

extraction arm contains an integrated Lamp & Arc Sensor Kit.

The supply cable inside the base swivel mount

should hang down vertically. Do not remove the

wire bridge.

See Figure A.12 for steps 4-7

Remove the wire bridge from the supply cable inside the base

swivel mount.

Connect the supply cables of the Prism

Mobile Base Unit and

the extraction arm.

NOTE: If you are using an older Mobiflex 200-M with an older

connection on the supply side, use the supplied adapter cable

S31224-62 in the loose hardware kit.

FIGURE A.12

8. Remove the plastic and tape packaging from the arm

sections. Adjust the friction of the arm and hood movement

as described in the maintenance section of this manual.

When set, seal all hose connections with the arm seal bands.

9. Fold back 2/3 of both arm seal bands. Remove the wrap of

sections. To secure the hose, at least one metal rings of the

hose should be applied over the ridges at each arm section.

Fold back the arm seal bands and place them over the hose.

The arm seal band should cover the arm section 0.5-1 in. See

Figure A.13

FIGURE A.13

ATTENTION

0.5 - 1in. overlap

of arm band seal

on the arm

Place at least

one metal band

of flexible hose

over ridge

Stretch arm band seal

over flexible tube

6. Remove the yellow tape from both arm sections.

7. Turn the extraction arm 359° and check whether the supply

cable is long enough. If necessary, pull the supply cable of the

Prism

Mobile Base Unit to a sufficient length.

Bekijk gratis de handleiding van Lincoln Electric Fume Extraction Arms, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.