Lincoln Electric Fume Extraction Arms handleiding

Niet gecategoriseerd

Lincoln Electric

50 pagina's

PDF beschikbaar

Handleiding

A-5

INSTALLATIONFUME EXTRACTION ARMS

Read this entire installation section before you

start installation.

INSTALLATION

ELECTRIC SHOCK CAN KILL.

• Only qualied personnel should perform

this installation.

• Turn the input power OFF and unplug

the machine from the receptacle before

working on this equipment.

• Insulate yourself from the work and ground.

• Always connect the machine to a power supply

grounded according to the National Electrical Code and

local codes.

MOVING PARTS can injure.

• Do not operate with covers open or

lter removed.

• Keep away from moving parts.

TIPPING Hazard

Unit is to be used on at surface only.

The extraction arm must be fastened in an upright and

folded position during transport of the unit.

Only qualied personnel should install, use or

service this equipment.

SELECT SUITABLE LOCATION

• Inspect the product and check it for damage. Verify the

functioning of the safety features.

• During use, always use Personal Protective Equipment (PPE)

to avoid injury. This also applies for persons who enter the

work area.

• Check the working environment. Do not allow unauthorized

persons to enter the working environment.

• Protect the product against water and humidity.

• Make sure the room is always sufficiently ventilated; this

applies especially to confined spaces.

The installer is responsible for following local

safety codes and regulations.

Before drilling, verify locations of existing gas, water, or

electrical conduits.

For mounting compatibility see “EXTRACTION

ARM MOUNTING COMPATIBILITY” table

located on page A-1.

For wall mounting applications:

Install wall mounting brackets as detailed in the section titled

“INSTALLATION OF WALL MOUNTING BRACKETS” for Operator

Manual included with the Prism 2400 Stationary Fan.

• Telescopic Counter Weight arm includes mount

assembly. See wall mounting instruction on page A-12.

• FOR ARC SENSOR/LAMP KIT APPLICATIONS:

Install the wiring for the lamp kit as detailed in the

section titled “Installing the Lamp Kit” for operator

manual included with the Lamp Kit for Wall Mounted

Systems

Tools and requirements

The following tools are needed to mount and maintain extraction

arms.

• 9/16” wrench and socket

• 1/2” wrench and socket

• 7/16” wrench and socket

• Oil lubricant

• Grease lubricant

• Utility knife

• PPE - safety glasses and gloves

• 1/8” hex bit

WARNING

CAUTION

Bekijk gratis de handleiding van Lincoln Electric Fume Extraction Arms, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.