Handleiding
Je bekijkt pagina 17 van 38
Fig.61
u
Carry out action steps according to the illustration.
w
MaxIce is deactivated.
TubeClean *
You can use this function to activate or deactivate Tube‐
Clean. If TubeClean is activated, it cleans the IceMaker lines.
Activating TubeClean
Make sure that the following requirements are fulfilled:
q
IceMaker cleaning is prepared. (see 9.5.4 Cleaning the
IceMaker*)
q
Empty container with a capacity of 1.5 l and with a
maximum height of 10cm is ready.
u
Place the container in the drawer under the IceMaker.
Fig. 62
Fig.63
u
Carry out action steps according to the illustration.
w
TubeClean is activated.
w
The cleaning process has started: Icon flashes until
the cleaning process is automatically completed after
60 minutes.
w
When the cleaning process is complete: The device
continues to run in normal mode.
Deactivating TubeClean
TubeClean is automatically ended after 60 minutes.
However, TubeClean can also be deactivated at any time
during the cleaning process:
Fig.64
u
Carry out action steps according to the illustration.
w
TubeClean is deactivated: Cleaning process is aborted.
w
The device continues to run in normal mode.
CleaningMode*
You can use this function to activate or deactivate Cleaning‐
Mode. CleaningMode enables the appliance to be cleaned
conveniently.
This setting applies to the fridge section.
Application:
-
Clean the fridge section. (see 9.5Cleaning the appliance)
Device status when CleaningMode is active
The status display shows CleaningMode permanently.
The fridge section is switched off.
Interior lighting is activated.
The reminders and warnings are not displayed. No signal
tone sounds.
Device status
Activating CleaningMode
Fig.65
Fig.66
u
Carry out action steps according to the illustration.
w
CleaningMode is activated.
w
The status display shows CleaningMode permanently.
Deactivating CleaningMode
CleaningMode is deactivated automatically after
60 minutes. However, you can also deactivate Cleaning‐
Mode manually at any time:
Fig. 67
u
Carry out action steps according to the illustration.
w
CleaningMode is deactivated.
w
The appliance cools to the temperature set previously.
Display brightness
Use this function to set the display brightness in stages.
You can select the following brightness levels:
-
40%
-
60%
-
80%
-
100 % (pre-setting)
Setting the brightness
Fig.68
Controls
* Depending on model and options 17
Bekijk gratis de handleiding van Liebherr IKGS 51Ve03 Pure, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Liebherr |
| Model | IKGS 51Ve03 Pure |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 5903 MB |
