Handleiding
Je bekijkt pagina 31 van 64
31INSTALLATION
ENGLISH
the system checked immediately, as
performance will be poor.
5 End of cycle.
• At the end of the test cycle, a message will
display. The test cycle will end and the
appliance will shut off automatically after a
short delay.
Check the Duct Condition
If the Flow Sense
TM
LED is turned on, check the
exhaust system for restrictions and damage.
Repair or replace the exhaust system as needed.
NOTE
• When the appliance is first installed, this test
should be performed to alert you to any existing
problems with the exhaust duct in your home.
However, since the test performed during
normal operation provides more accurate
information on the condition of the exhaust duct
than the installation test, the results during the
two tests may not be the same.
• Do not interrupt the test cycle, as this could
result in inaccurate results.
• Even if the LED doesn't light up during the test
cycle, some restrictions may still be present in
the exhaust system. Refer to the Venting the
Dryer section of this manual for complete
exhaust system and venting requirements.
Error Messages
Check the error message before you call for
service.
Restricted or Blocked Airflow
Avoid long runs or runs with multiple elbows or
bends.
Check for blockages and lint buildup.
Error Message Possible Cause & Solution
Temp sensor
error 1
Temperature sensor failure.
• Turn off the appliance and
call for service.
Humidity sensor
error
Humidity sensor failure.
• Turn off the appliance and
call for service.
High voltage
Low voltage
Power supply
Electric dryer power cord is
not connected correctly, or
house power supply is
incorrect.
• Reset circuit breaker or
replace fuse. Do not
increase the fuse capacity.
House fuse is blown, circuit
breaker has tripped, or
power outage has occurred.
• If the problem is a circuit
overload, have it corrected
by a qualified electrician.
Gas supply Gas supply or service turned
off. (gas model only.)
• Confirm that house gas
shutoff and the dryer gas
shutoff are both fully
open.
Excess or crushed
transition duct
Too many elbows or
exhaust too long
Error Message Possible Cause & Solution
Bekijk gratis de handleiding van LG DX8601WE, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | LG |
| Model | DX8601WE |
| Categorie | Wasdroger |
| Taal | Nederlands |
| Grootte | 6042 MB |
