LG DLEX9900S handleiding

64 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 30 van 64
30 INSTALLATION
4 Check the display for results.
During the test cycle, monitor the error
messages displayed on the control panel. If
the duct blockage message has not been
displayed when the cycle ends, the exhaust
system is adequate. If the exhaust system is
severely restricted, the duct blockage
message will be displayed. Other problems
may also be shown with error codes. See
the chart for error code details and
solutions.
If the duct blockage message displays that
the exhaust system is severely restricted,
have the system checked immediately, as
performance will be poor.
5 End of cycle.
At the end of the test cycle, the Done
message will display. The test cycle will end
and the appliance will shut off automatically
after a short delay.
Check the Duct Condition
If the duct blockage message is turned on, check
the exhaust system for restrictions and damage.
Repair or replace the exhaust system as needed.
NOTE
When the appliance is first installed, this test
should be performed to alert you to any existing
problems with the exhaust duct in your home.
However, since the test performed during
normal operation provides more accurate
information on the condition of the exhaust duct
than the installation test, the results during the
two tests may not be the same.
Do not interrupt the test cycle, as this could
result in inaccurate results.
Even if the duct blockage message isn't
displayed during the test cycle, some restrictions
may still be present in the exhaust system. Refer
to the Venting the Dryer section of this manual
for complete exhaust system and venting
requirements.
Error Codes
Check the error code before you call for service.
Restricted or Blocked Airflow
Avoid long runs or runs with multiple elbows or
bends.
Error
Code
Possible Cause & Solution
Temp
sensor
error 1
Temperature sensor failure.
Turn off the appliance and call for
service.
Humidity
sensor
error
Humidity sensor failure.
Turn off the appliance and call for
service.
Power
supply
High
voltage
Low
voltage
Electric dryer power cord is not
connected correctly, or house
power supply is incorrect.
Reset circuit breaker or replace
fuse. Do not increase the fuse
capacity.
House fuse is blown, circuit breaker
has tripped, or power outage has
occurred.
If the problem is a circuit
overload, have it corrected by a
qualified electrician.
Gas
supply
Gas supply or service turned off.
(Gas model only.)
Confirm that the house gas
shutoff and the dryer gas shutoff
are both fully open.
Duct
blockage
(80%),
(90%),
(95%)
Exhaust system is too long or has
too many turns/restrictions.
Do not use the appliance until the
exhaust system has been cleaned
and/or repaired. Using the
appliance with a severely
restricted exhaust is dangerous
and could result in a fire or other
property damage.
Check the outside dryer vent while
the appliance is operating to make
sure there is strong airflow. if the
exhaust system is extremely long,
have it repaired or rerouted.
Door
open
Door is open.
Do not open the door when
running the installation mode.
After closing the door completely,
restart Installation mode.

Bekijk gratis de handleiding van LG DLEX9900S, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkLG
ModelDLEX9900S
CategorieWasdroger
TaalNederlands
Grootte5763 MB