Levenhuk LabZZ SK40 handleiding

Niet gecategoriseerd

Levenhuk

24 pagina's

PDF beschikbaar

Handleiding

Walkie-talkie

Getting started

Press the fastener (23) and pull the pocket clip (24) gently. Open the battery compartment cover and insert 4 AAA batteries according to the correct polarity.

Close the cover until it clicks. Repeat the same steps with the second device.

Using the walkie-talkie

To turn the device on, press and hold the On/O button (6) for 3 seconds.

The volume level is controlled by the UP (4) and DOWN (7) buttons.

Both walkie-talkies must be tuned to the same channel and CTCSS tone/DCS code (if used), so that you can communicate. Press the MENU button (11) — the

channel digit will start blinking. Select one of the channels using the UP (4) and DOWN (7) buttons and press the TALK button (15) to conrm the choice. To

select the CTCSS tone/DCS code for the current channel, press the MENU button (11) twice, specify the encoding type, and then one of the codes. To save the

settings, press the TALK button (15).

To call the other person, press the CALL button (12). During the conversation, the transfer icon (TX) will be shown on the screen.

Press the TALK button (15) to send a voice message and keep it pressed while speaking. Aer the button is released, the device will give a short beep tone,

indicating that the device has switched to receiving mode.

To turn the backlight on, press any button except the MENU button (11) and the monitoring button (5).

To reset to the factory settings turn the device o, press the UP button (4) and turn the device on again.

Other functions

Monitoring — is used in case of an unstable signal. It disables the squelch function so that all the signals on the selected channel become audible.

Scan — checks all channels for activity, stopping at each channel where activity is detected. Press the TALK button (15) to stop on the selected channel.

VOX — activates voice activated transmission. Using VOX and connecting a headset, you can go on the air without pressing buttons. VOX mode is switched on/

o via the MENU button (11).

Keypad lock — allows you to exclude the accidental pressing of buttons. To activate this mode, press and hold the MENU button (11) for 2 seconds.

The TALK and CALL buttons will remain active!

Squelch — turns on automatically.

Specications

Frequency range 446MHz

Channels 8

Radio signal radius up to 3km /1.8mi.

Squelch +

VOX +

Monitoring +

Scan function +

Power source 4 AAA batteries (for each device)

Transmission power 0.5W

Operating temperature range –20… +50°C / –4… +122°F

Care & maintenance

Do not use the device in potentially explosive environments or while riding a bicycle or driving a car or any other vehicle.

Consult your doctor about the safety of the device regarding any medical device you may be using.

Do not use the device near radio sources as it may cause interference.

Use a so, damp cloth to clean the device. Do not use any ethanol- or acetone-based uids on it.

Warranty: lifetime. For further details, please visit our web site: www.levenhuk.com/warranty

The manufacturer reserves the right to make changes to the product range and specications without prior notice.

Bekijk gratis de handleiding van Levenhuk LabZZ SK40, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.