Handleiding
Je bekijkt pagina 59 van 72
Use a Golden Key U1 tool to flash-write key id information
After replacing the system board and re-assembling the computer, use a pre-made Golden Key U1 tool to
start the computer and flash-write the serial number (SN), machine type (MT), product name (PN), and UUID
to the new system board.
The Golden Key U1 tool is prepared by running the U1 Update software on a FAT32-formatted USB thumb
drive. Go to
http://support.lenovo.com/us/en/solutions/HT506954 for detailed instructions on how to create
and use a Goldern Key U1 tool.
Remove the touch pad cable
Make sure the following FRUs (or CRUs) have been removed.
“Remove the lower case” on page 28
“Remove the battery pack” on page 33
“Remove the system board” on page 50
Step 1. Peel off the touch pad waterproof mylar.
Figure 41. Peel off the touch pad waterproof mylar
Step 2. Disconnect and remove the touch pad cable.
Chapter 4. Removing a FRU or CRU 53
Bekijk gratis de handleiding van Lenovo V17 Gen 3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lenovo |
| Model | V17 Gen 3 |
| Categorie | Laptop |
| Taal | Nederlands |
| Grootte | 18565 MB |
