Handleiding
Je bekijkt pagina 80 van 100
3. Close the computer display and turn over the computer.
4. Remove the Lenovo Integrated Pen or pen dummy. See “Lenovo Integrated Pen and pen dummy (for
selected models)” on page 66.
5. Remove the base cover assembly. See “Base cover assembly” on page 67.
Tool needed: Phillips-head screwdriver
Step 1. Remove the M.2 solid-state drive and its bracket as shown below.
Step 2. Install the M.2 solid-state drive and its bracket in reverse order.
Memory module
Follow the instructions to replace the memory module.
Before you start, read
Generic Safety and Compliance Notices.
Attention: Do not touch the contact edge of the memory module. Otherwise, the memory module might get
damaged.
For access, do the following:
1. Disable Fast Startup and the built-in battery. See “Before you replace any CRU” on page 66.
2. Turn off the computer and disconnect the computer from ac power and all connected cables.
3. Close the computer display and turn the computer over.
4. Remove the Lenovo Integrated Pen or pen dummy. See “Lenovo Integrated Pen and pen dummy (for
selected models)” on page 66.
5. Remove the base cover assembly. See “Base cover assembly” on page 67.
Step 1. Remove the memory module as shown below.
Note: A Mylar film might cover the memory module. To access the memory module, peel off the
film first.
74
User Guide
Bekijk gratis de handleiding van Lenovo 13w 2-in-1 Gen 3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lenovo |
| Model | 13w 2-in-1 Gen 3 |
| Categorie | Laptop |
| Taal | Nederlands |
| Grootte | 12729 MB |
