Lectrosonics M2T/E01 handleiding
Handleiding
Je bekijkt pagina 5 van 24
Digital IEM Transmitter
Rio Rancho, NM
5
• Standard: The Standard key type oers enhanced
security, at the cost of some complexity. Standard
keys are “instance controlled”, which allows the
hardware to protect against “dierential attacks”.
A Standard key can only be sent by the device that
created it, and only up to 256 times. Unlike with
Shared keys, devices receiving a Standard key
cannot pass it on.
• Volatile: The Volatile key type is the most secure,
and also the least convenient to use. Volatile keys
behave identically to Standard keys, except that
they are never stored. Equipment which is turned
o while using a Volatile key will come back on
with no key. If a key-generating device is left on,
the key can be re-shared with units in the system
that have lost their keys. Once all equipment hav-
ing used a given Volatile key is powered o, that
key is eectively destroyed. This may be required
in some highly secure installations.
System Setup Procedures
Summary of Steps
1) Connect power using supplied DCR15/4AU power
supply.
2) Power receiver and scan RF spectrum on site.
3) Sync Scan to transfer information from receiver
to transmitter.
4) Tune transmitter to unoccupied channels in scan.
5) Sync receiver (refer to receiver manual).
6) Turn on transmitter RF.
7) Send audio sources to transmitter.
WARNING: Increasing the Pregain can make
headphone volume excessively loud. Use
caution when setting and using.
Bekijk gratis de handleiding van Lectrosonics M2T/E01, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lectrosonics |
| Model | M2T/E01 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 10631 MB |
