Lectrosonics M2Ra-B1C1 handleiding
Handleiding
Je bekijkt pagina 17 van 20
Digital IEM Receiver
Rio Rancho, NM 17
Specications
Operating Spectrum (dependent on Locale):
NA: 470.100 - 607.950 MHz
EU: 470.100 - 614.375 MHz
AU: 520.000 - 614.375 MHz
JA: 470.150 - 614.375 MHz
EU: 537.600 - 691.175 MHz
AU: 537.600 - 691.175 MHz
JA: 537.600 - 691.175 MHz
Modulation Type: 8PSK with Forward Error
Correction
Encryption Type: AES-256 in CTR mode
Latency: (overall system)
Digital Source: 1.0 ms plus Dante network
Analog Source: <1.6 ms
Audio Performance:
Frequency Response: 10 Hz - 12 KHz, +0, -3dB
THD+N: 0.15% (1kHz @ -10 dBFS)
Dynamic Range: >95 dB weighted
Adj. Channel Isolation >85dB
Third Order Intercept: +15 dBu
Diversity Type: Switched antenna phase, during
packet headers
Audio Output: 3.5 mm stereo jack
Power requirements: 2 x AA batteries (3.0V)
Battery life: 7 hours; (2) Lithium AA
Power consumption: 1 W
Dimensions: Height: 3.5 in. / 90 mm. (with knob)
Width: 2.375 in. / 60.325 mm.
Depth: .625 in. / 15.875 mm.
Weight: 5.6 ounces / 159 grams (with
batteries)
Specications subject to change without notice.
Wireless Designer
Software
Download the Wireless Designer software installer from
the web sites under the SUPPORT tab at:
https://lectrosonics.com/wireless-designer.html
NOTE: If Wireless Designer is already installed,
you must uninstall it before attempting to install
a new copy.
Firmware Update
Instructions
Firmware updates are made with Wireless Designer
software and a file downloaded from the web site
and the M2Ra connected via USB. Firmware files are
located at https://lectrosonics.com/firmware.html
and Wireless Designer software can be downloaded
for Mac or Windows here https://lectrosonics.com/
wireless-designer.html.
The USB port on the transmitter requires a micro-B
male plug on the connecting cable. The other end
of the cable would normally be a USB A-Type male
connector to fit the most common type of USB jack
used on computers. Our part number for this cable is
21926.
Step 1:
Connect your computer to the M2Ra using the USB cable.
The receiver will automatically power on into Update mode.
Step 2:
Start Wireless Designer and under the “Connect (Live)”
menu, scroll down to Update Firmware, and in the Duet
submenu, click on M2Ra.
Step 3:
Follow the on-screen instructions to choose the update
le, check to see if an update is needed, and initiate the
update process. When nished, check the rmware ver-
sion in Setup>About to verify the update.
A1B1
B1C1
Bekijk gratis de handleiding van Lectrosonics M2Ra-B1C1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lectrosonics |
| Model | M2Ra-B1C1 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7254 MB |
