Lavor GV Etna 5.1 handleiding
Handleiding
Je bekijkt pagina 21 van 100
is possible to use the above-mentioned
steamcleaning functions together.
• Vacuum by pressing button L1
• When work is finished, release the steam le-
ver L3 a few moments prior to switching off
the suction motor L1. This will allow the suc-
tion ducts to recover the humidity.
FOAM CLEANING
Only model ETNA 4.1 FOAM:
32
Connect the device to a minimum 5 bar
air compressor (not supplied).
33
Using specific detergents is indispensa-
ble for foam production.
•
Insert antifoam additive in the tank, 50 cc.
• Insert the compressed air fitting hose in V1
(hose not supplied).
• Adjust the air pressure from 2 to 5 bar with
knob V3.
• Fit the most suitable accessory in the handle
of the flexible hose L.
• Connect the device to a suitable electrical
outlet.
• Start by pressing main switch B.
• Selection switch P1 to the air position
AIR (II)
• Selection switch P to position
(I) detergent.
• For foam outflow, press lever L3
• Distribute the foam.
• Leave the detergent on for 1 minute.
• Vacuum by pressing button L1
• When work is finished, release the steam le-
ver L3 a few moments prior to switching off
the suction motor L1. This will allow the suc-
tion ducts to recover the humidity.
RINSING WITH AIR AND WATER
Only model
ETNA 4.1 FOAM:
32
Connect the device to a minimum 5 bar
air compressor (not supplied).
• Insert the compressed air fitting hose in
V1 (
hose
not supplied)
• Adjust the air pressure to the maximum with knob
V3
.
• Fit the most suitable accessory in the handle
of the flexible hose L.
• Connect the device to a suitable electrical
outlet.
• Start by pressing main switch B.
•
Selection
switch
P1
to the position
AIR
(II)
•
Selection
switch
P
to the position
H2O (II)
water
• For air and water outflow, press lever
L3
• Vacuum by pressing button
L1
.
TOPPING UP THE BOILER WATER TANK WITH WA-
TER
• The boiler water tank L supplies the boiler
through an electronic level control; since this
is an external tank, it can be topped up any
time.
• When water runs out in the boiler water
tank:
1. the appliance beeps intermittently
2. the no-water level pilot light C flashes
3. the steam stops coming out
To top up, proceed as follows:
• Switch off the boiler switch E
• Turn off the main switch B
• Remove the cable from the socket
• Fill the boiler water tank J
AFTER USE
• Every time you finish working, put switch P,
P1, E, B in OFF position.
• Extract the plug from the wall socket.
REMOVING THE HEAD
Before taking the head A off of the drum I, re-
move the prove K from the tank (fig. 7)
• Release the hooks G and raise the head A (Fig. 8
and 9).
• Put the washable filter on the head (Fig. 10 and
11).
EN
21
Bekijk gratis de handleiding van Lavor GV Etna 5.1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lavor |
| Model | GV Etna 5.1 |
| Categorie | Stoomreiniger |
| Taal | Nederlands |
| Grootte | 17718 MB |
