Lavex 842CD123ST12 handleiding
Handleiding
Je bekijkt pagina 12 van 12
(12) Lavex 12-Gallon, 500 PSI Carpet Extractor Lavex 12-Gallon, 500 PSI Carpet Extractor (13)
7.0 Storing your Carpet Extractor
Store your carpet extractor in temperatures over 40 degrees Fahrenheit. To prevent
moisture from damaging the vacuum motor during storage, empty the recovery tank and
store with the lid open. Store in an upright position in a dry area
If you plan on storing your extractor in freezing conditions or for a long period of time,
you must winterize your carpet extractor to protect the pump from freezing also damage
being caused to ttings and valves. Damage due to freezing is NOT covered under
the warranty. The following procedure should help prevent your carpet extractor from
freezing and prevent pump and seals from drying out.
Recommended Procedure for Storage
• Pour a quart of RV Water System Antifreeze into the solution tank.
• Connect the solution hose to the front of the machine.
• Use the wand to spray the mixture into a bucket.
• Vacuum the excess mixture out of the solution tank and into the recovery tank.
Dispose of the antifreeze properly.
To return to service, ush the pressure system by repeating the above steps, using
fresh water in place of antifreeze.
8.0 How to Use Heater & Maintenance
Preventative Instructions for Heater Use
Before Initial Use
• Drain antifreeze from the machine system.
• Ensure secure outlet connection with no loose parts.
• Conrm correct pigtail attachment.
• Use only Lavex-approved extensions to prevent malfunctions.
• For long-term storage, use antifreeze every two months, especially in hot areas to
prevent scale buildup.
• In cold climates, use antifreeze and store the unit in a location above 65°F to prevent
heater damage.
During Heater Use
• Activate both pump and heater buttons simultaneously.
• Allow 5 minutes for water to heat with pump running before use.
• Alternate between 5-minute vacuuming and 5-minute hot water use intervals.
• Allow at least 2 minutes for hot water to ow from the unit.
• DO NOT pour hot water into the solution tank.
After Heater Use
• Rinse the machine system with a 50/50 vinegar-water solution (5 gallons for extractors), then
ush with water to maintain pump and system condition.
6.0 Shutdown Procedures
• When nished cleaning, turn OFF all switches.
• Disconnect the solution hose and vacuum
hose from the cleaning tool. Pull the valve
trigger to release pressure from the hose before
disconnecting the solution hose from the
cleaning tool.
• If water remains in the solution tank, use
the vacuum hose and vacuum the excess water
from the tank (Figure 1).
• Disconnect the power cords from the outlets and
from the machine.
• Remove the oat assembly from the recovery
tank and clean lter as needed. Replace oat
assembly and tank lid (Figure 2).
• Drain any remaining water from the recovery
tank and dispose of in a sanitary drain.
CAUTION: use separate buckets to drain and
ll the tank. Even the smallest debris can cause
issues (Figure 3)
• Disconnect and roll-up all hoses and tools. Store
machine and accessories in a dry space.
Figure 1
Figure 2
Figure 3
Bekijk gratis de handleiding van Lavex 842CD123ST12, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lavex |
| Model | 842CD123ST12 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3724 MB |
