Laserworld CS-24.000RGB FX handleiding
Handleiding
Je bekijkt pagina 7 van 19
Manual: CS-24.000RGB FX Manual: CS-24.000RGB FX
page 12 / 37 page 13 / 37
English English
Master Setting
The „uAST“ menu allows for the activation and deactivation of the Master mode for the laser.
If the laser is set to Master > On, then it can be used as Master device in a Master-Slave setup.
See more in „4.3. Master-Slave“.
Press „Enter“ to change the settings. Use the „Up“ / „Down“ button to change the selection.
Conrm with „Enter“.
Safety Setting
The „bEAu“ menu can switch the beam block safety on and o. The beam block safety
prevents that very intense, single beams can be displayed. It is highly recommended to not
switch this feature o. Switching o the beam block safety is at your own risk! Lasers with
switched o beam block safety may only be used in safe areas.
Always respect the local laws!
Press „Enter“ to change the settings. Use the „Up“ / „Down“ button to change the selection.
Conrm with „Enter“.
Orientation Setting
The „InuE“ menu controls the orientation of the projection. You can invert the projection and
ip it to match the orientation of the laser with the content.
Press „Enter“ to change the settings. A test picture is shown to represent the currently set
orientation. Use the „Up“ / „Down“ button to change the selection, and conrm the selection
with „Enter“ to change the test picture projection
Press „Exit“ to return to the settings menu.
Microphone Sensitivity Settings
The sensitivity of the built-in microphone for the control of the sound-to-light operation can
be adjusted in the „SEnS“ menu. Press „Enter“ to change the settings. Use the „Up“ / „Down“
button to change the selection.
The sensitivity can be adjusted between 1 and 100. Standard value is 50.
4.6. ILDA / COMPUTER CONTROL
The laser can be used with any laser control software that supports the ILDA control signal
via sub-d connector. Use an ILDA cable to connect the Digital Analog Converter (DAC / ILDA
interface) of the laser software to the ILDA in port at the laser.
To operate the laser in ILDA mode the „ILdA“ menu must be selected. Press „Enter“ to change
the settings.
Grating Eects Settings in ILDA mode - DMX grating control on ILDA
Once ILDA mode is selected, the standard selection is „L001“, which means that the laser will
automatically switch through the grating eects. A certain grating eect can be selected
with L002, L003, L004. If L005 is selected there is no grating eect.
Use the „Up“ / „Down“ button to change the selection:
For DMX control of grating eects while on ILDA:
• set a DMX address as specied in „4.4 DMX 512“ section
• select „d512“ in the backpanel and press Enter
• on the DMX control you have to turn channel 1 to 255, channel 15 to 1-199 and then
you can control the Grating wheel with channel 14.
Bekijk gratis de handleiding van Laserworld CS-24.000RGB FX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Laserworld |
| Model | CS-24.000RGB FX |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4668 MB |
