Laserliner DigiLevel Pro 40 handleiding

Niet gecategoriseerd

Laserliner

52 pagina's

PDF beschikbaar

Handleiding

The unit is properly calibrated when it displays the same

measurement value, i.e. the underlying surface‘s deviation

from absolute level, in both positions (0° and 180°).

3. Now turn the unit around horizontally (end-for-end) by 180°

such that its ends are positioned opposite where they previously

were but again exactly at the underlying surface marks (reverse

measurement).

Then press the READ button (1) again. -2- ashes.

The subsequent acoustic signal concludes the process.

2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58

READ

HOLD

CALREF

mm/m

SET

DigiLevel Pro

Rev19W38

LASER RADIATION! DO NOT STARE

INTO THE BEAM! CLASS 2 LASER

< 1 mW · 635 nm · EN 60825-1:2014/AC:2017

LASERSTRAHLUNG!

NICHT IN DEN STRAHL BLICKEN!

LASERKLASSE 2 · < 1 mW · 635 nm

EN 60825-1:2014/AC:2017

DigiLevel Pro 60

A quality product from

GmbH & Co. KG

Donnerfeld 2, 59757 Arnsberg

Germany, Tel: +49 2932 638-300

Fax: -333, www.laserliner.com

WARNING

With magnet

on the bottom

Hold down the HOLD button (6) to keep displaying the current

measured value.

HOLD5

1. Place the unit with its measuring edge (13) down on a straight

surface and mark the positions of the unit‘s ends on the under-

lying surface (see Fig. below). Switch on device (1). To access

calibration mode simultaneously press buttons 1 and 3.

-1- appears on the display.

2. Then press the READ button (1). -1- ashes.

The display then changes to -2-.

Calibration

Button (5) allows the desired unit of measurement to be selected

(° degrees, %, mm/m).

Selection of unit of measurement

The DigiLevel Pro 40/60/80 can measure angles continuously to 360°.

– Switch the DigiLevel Plus on using the on/off switch (1).

– The slope angle is shown in the display (l). If slopes are measured

overhead, the direction of display adjusts automatically.

– The current slope direction is also shown by the symbol (a).

Make sure that the reference function is deactivated before

measuring.

Switching on and measuring

Bekijk gratis de handleiding van Laserliner DigiLevel Pro 40, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.