Lantronix TN-SFP-10G-SR handleiding
Handleiding
Je bekijkt pagina 10 van 21
Lantronix TN-SFP-10G-xx and TN-CWDM-10G-xxx User Guide
33499 Rev. E https://www.lantronix.com/ 10
SFP Unpacking
SFPs can be packaged and shipped in a Single package or in a Pack (e.g., TN-SFP-10G-LR-PK is a Pack of 20 TN-
SFP-10G-LR SFPs). Before you start installing the TN-SFP-xxx, verify that the package contains the following items:
o One TN-SFP-xxx device
o One printed Insert Card
o One printed Caution statement
Please notify your sales representative immediately if any of the above items is missing or damaged. Save the packaging
for possible future use.
SFP Installation
Cautions
• The SFP module is keyed to only be installed one way. If forced the wrong way, damage may occur.
• Avoid getting dust or other contaminants into the fiber bore of the SFP transceiver module, as this will cause the
optics to not operate properly.
• Clean the optic surfaces of the optical fiber before you plug them back in to the optical bores of another SFP module.
See Fiber Optic Association Cleaning Fiber Optic Connections page.
• Each port must match the wavelength specifications on the other end of the cable, and the cable must not exceed the
specified cable length for reliable communications.
• TN-SFP distances, TX power, RX power, and link budgets can be found on the Lantronix website. The fiber optic
transmitters on this device meet Class I Laser safety requirements per IEC-825/CDRH standards and comply with 21
CFR1040.10 and 21CFR1040.11. WARNING: Visible and invisible laser radiation when open. Do not stare into the
beam or view the beam directly with optical instruments. Failure to observe this warning could result in an eye injury
or blindness. IMPORTANT: Copper based media ports such as Twisted Pair (TP) Ethernet, USB, RS232, RS422,
RS485, DS1, DS3, Video Coax, etc., are intended to be connected to intra-building (inside plant) link segments that
are not subject to lightening transients or power faults. Copper-based media ports such as Twisted Pair (TP) Ethernet,
USB, RS232, RS422, RS485, DS1, DS3, Video Coax, etc., are NOT to be connected to inter-building (outside plant)
link segments that are subject to lightening transients or power faults.
Bekijk gratis de handleiding van Lantronix TN-SFP-10G-SR, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lantronix |
| Model | TN-SFP-10G-SR |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4297 MB |
