Lantronix ION C2210 handleiding
Handleiding
Je bekijkt pagina 4 van 17
Lantronix ION C2210 Installation Guide
33416 Rev. C https://www.lantronix.com Page 4 of 17
Product Description
The ION C2210 is a media converter module that provides an interface between 10/100Base-TX ports and
100Base-FX ports, allowing users to integrate fiber optic cabling into 10/100 copper environments. Operating at
Layer 2, the data link layer, this converter not only converts copper to fiber, it also provides rate conversion
allowing legacy 10Base-T copper devices to connect to 100Base-FX fiber. The ION C2210 is a manageable
device when installed in a managed ION chassis.
Ordering Information
Part Number Port 1 – Copper 10/100-Base-T Port 2 - Duplex Fiber-Optic 100Base-FX
C2210-1011 RJ-45; 100 m (328 ft) ST, 1300 nm multimode; 2 km (1.2 miles)*
C2210-1013 RJ-45; 100 m (328 ft) SC, 1300 nm multimode; 2 km (1.2 miles)*
C2210-1014 RJ-45; 100 m (328 ft) SC, 1300 nm single mode; 20 km (12.4 miles)
C2210-1019 RJ-45; 100 m (328 ft) LC, 1300 nm multimode; 2Km (1.2 miles)*
C2210-1039 RJ-45; 100 m (328 ft) LC, 1300 nm multimode; 20Km (12.4 miles)*
C2210-1040 RJ-45; 100 m (328 ft) SFP slot (empty)
*Typical maximum cable distance. Actual distance depends on network physical characteristics.
** Install C2210-1029-xx and C2210-1029-xx single-fiber optic in the same network where one is the local
converter and the other is the remote converter.
Features
• Fast Ethernet
• One Copper & One Fiber Port
• 10/100Base-TX to 100Base-FX Connectivity
• Auto-Negotiation of speed and duplex on TP port
• Auto-MDI/MDIX on TP port
• Link Pass Through (LPT)
• Far-End-Fault (FEF) detection
• Pause (Software Controlled)
• Automatic Link Restoration
• Field Upgradeable Firmware
• Can be used in any ION Platform Chassis
• Standards based, will link with any Standard 10/100Base-TX and any Standard 100Base-FX ports
Manageable Features
• Report converter status to chassis management software:
o TP and Fiber Link Status
o Hardware switch settings
o Copper Port Speed
o TP and Fiber Port Duplex
o Fault condition
• Write operation includes:
o Power on/off device
o Auto-Negotiation enable/disable
o Force 10 Mbps or 100 Mbps
o Force half or full-duplex
o Select advertising modes when
o Auto-Negotiation is enabled
Bekijk gratis de handleiding van Lantronix ION C2210, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lantronix |
| Model | ION C2210 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2082 MB |
