Lantronix ION C2110 handleiding
Handleiding
Je bekijkt pagina 8 van 23
Lantronix C2110 Install Guide
33415 Rev. D https://www.lantronix.com Page 8 of 23
Set AutoCross (E/D 3-Pin Jumper) (J4)
When the AutoCross feature is enabled, it allows either straight-through or crossover cables to be used
when connecting to 100Base-TX devices. AutoCross determines the characteristics of the connection and
automatically configures the unit to link up, regardless of the cable configuration. Note: AutoCross is
enabled by default. Lantronix recommends leaving jumper J4 in the “Enabled” position.
The 3-pin header J4 for the jumper is located on the PCB and is labeled “E” (Enabled) and “D” (Disabled).
The default is E (Enabled). Use a small needle-nose pliers to remove and position the jumper.
The J4 settings are shown and described below:
E - Enable: the C2110 connects automatically to either straight-through or crossover twisted-pair copper
cable.
D - Disable: either straight-through or crossover twisted pair copper cable must be installed, according to
site requirements.
Set Hardware / Software (H/S 3-Pin Jumper) (J5)
The 3-pin header J6 for the jumper is located on the PCB and is labeled “H” (Hardware mode) and “S”
(Software) mode. Use a small needle-nose pliers to remove and position the jumper.
The J5 settings are shown and described below:
H - Hardware: C2110 mode is determined by the 4-position DIP switch (SW1) settings (see above).
The default is Hardware mode.
S - Software: C2110 mode is determined by the most recently saved on-board ION software settings.
Bekijk gratis de handleiding van Lantronix ION C2110, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lantronix |
| Model | ION C2110 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6245 MB |
