La Germania DA2MN handleiding
Handleiding
Je bekijkt pagina 16 van 91
cylinder. Affix an edge of the hose on hose
inlet connector behind the appliance by
pushing to end through heating the hose in
boiled water. Afterward, bring the clamp
towards end section of the hose and tighten
it with screwdriver. The gasket and hose inlet
connector required for connection is as the
picture shown below.
NOTE:The regulator to be affixed on LPG cylinder should have 300
mmSS feature.
Main Gas Pipe
16
Gasket
Hose Inlet Connector
Metal Clamp
Lpg Connection Hose
GB
GasConnection
WARNING: Before starting any work related with gas installation, turn off
gas supply. Risk of explosion.
Please operate your oven in dry atmosphere.
1.Fit the clamp to the hose. Push one of the hose until it goes to the end
of the pipe.
2.For the sealing control; ensure that the buttons in the control panel are
closed, but the gas cylinder is open. Apply some soap bubbles to the
connection. Ifthere is gasleakage, there will be foaming in the soapedarea.
3.The oven should be using a well ventilation place and should be install
on flat ground.
4. Re-inspect the gas connection.
5.When placing your oven to its location, ensure that it is at the counter
level. Bring it to the counter level by adjusting the feet if necessary.
6.Do not make gas hose and electrical cable of your oven go through theheated
areas, especially through the rear side of the oven. Do not move gas connected
oven. Since the forcing shall loosenthe hose,gasleakagemay occur.
7. Please use flexible hose for gas connection.
For LPGconnection;
For LPG (cylinder) connection, affix metal
clamp on the hose coming from LPG
Bekijk gratis de handleiding van La Germania DA2MN, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | La Germania |
| Model | DA2MN |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 9355 MB |
