Handleiding
Je bekijkt pagina 7 van 25
KIBXX II/KWIBXX II ICEBERG SERIES SYSTEMS KWIKOOL
7
1. Align the holes of the flange to the holes located on the top of the unit. Attach to the top of the
KwiKool unit using the factory-supplied fasteners.
2. Attach each duct to the flanges on the replacement ceiling panel(s); secure the duct to each flange
using the supplied clamps.
3. Install the replacement ceiling panel(s) in the ceiling grid with the duct attached, connect the open
end of the duct to the flanges on your KwiKool and secure with supplied clamps.
NOTE
For areas with a closed ceiling or no ceiling use the double flange
ceiling kit method or extended duct method. The ceiling kit
replacement panel is not limited to ceiling use and may be placed
or fastened to any vertical or horizontal surface providing the
discharge and make-up air can be directed to the space where it
is mounted.
Visit www.KwiKool.com for more information and a complete set up guide.
F WATER COOLED CONDENSER
KWIBXX II Iceberg systems do not require a ceiling kit or duct to operate in the conditioned space.
Water from a recirculation source is used to remove heat from the condenser coil. A water valve that
maintains the optimum operating pressures of the system controls the flow of water in and out of the
Iceberg System. The recirculation source refers to a chilled water loop or cooling tower that supplies a
constant flow of water of at least 35 PSI but not more than 150 PSI and is above 40 degrees F but
below 85 degrees F, and can also return the discharge water for processing. There must be a water
supply and a place to discharge the water leaving the coil in order to operate the KWIBXX II system.
NOTE
Tap water is not used for operating this system due to the large
volume of water required. However, tap water may be used for
testing or proofing the KWIBXX as long as the temperature and
pressure requirements of the supply water are met. If tap water is
being supplied to the Iceberg, a way to discharge water must also
be available.
G WATER CONNECTION FOR WATER-COOLED (KWIBXX II) MODELS
Water-cooled systems are equipped with two brass female ½” (NPT) pipe thread connections located
on the lower left corner of the back panel for all systems up to 2.5 tons. Systems of 3.5 tons and up
have two female ¾” (NPT) pipe thread connections and 10-ton systems have four female ¾”
connections. Each fitting is labeled for Water In or Water Out.
Bekijk gratis de handleiding van KwiKool KIB3021-2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | KwiKool |
| Model | KIB3021-2 |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 3684 MB |
