KStrong UFS310030 handleiding
Handleiding
Je bekijkt pagina 16 van 28
16
29. INSTALLATION OF KSTRONG Micron™ WITH TIE-BACK HOOK
Kstrong Micron™ with tie-back hook (UFS359002) should be used with the SRL casing attached to the Dorsal D-ring of the full body
harness, and the extended webbing (with a sheath) wrapped around the anchorage structure, and the tie-back hook secured around the
webbing.
WARNING
• ALWAYS avoid lifeline contact with sharp or abrasive edges and surfaces.
• IftheMicron™withrebarhookcongurationisused,thentherebarhookshouldalwaysbeconnectedtotheanchoragestructure,
and NEVER to the dorsal D-ring of the full body harness. And the Micron™ casing should always be worn at the harness end. A
competent person must always ensure compatibility of the anchorage structure with the Micron™.
• For using the Micron™ as a twin-leg option, assemble two KStrong Micron™s (UFS354002) to connect to the dorsal D-ring of
the harness with the help of a special connector (e.g. UFC409151 ).
• When using the Micron™ as a twin-leg lanyard, then ensure 100% tie off at all times. Make sure to disengage one rebar hook from
theanchoragestructureonlyiftheotherhookisrmlyconnectedtotheanchoragestructure.
• The SRL should never be lubricated, and should always be kept away from oil.
30. TRAINING
It is essential that the users of this type of equipment receive proper training and instruction, including detailed procedures for the safe use
of such equipment in their work application. ANSI/ASSE Z359.2, Minimum Requirements for a Comprehensive Managed Fall Protection
Program, establishes guidelines and requirements for an employer’s managed fall protection program, including policies, duties and
training, fall protection procedures, eliminating and controlling fall hazards, rescue procedures, incident investigations, and evaluating
program effectiveness.
31. ADDITIONAL INFORMATION FOR SELF-RETRACTING LIFELINES
Always tag as “Unsuitable” those SRL’s which have been found to be unsuitable for further use. Never attempt to repair the equipment
on your own. Send the equipment so tagged to an authorized service center (where the authorization has been received from the
manufacturer in writing), or back to the manufacturer for replacement of components and repair.
32. MAINTENANCE
• Cleaning the equipment after use is extremely important, as this maintains the life and safety of the equipment. If soiled, the SRL’s
may be wiped off clean with a dry clean cloth. The equipment may also be cleaned using mild soap and water. Rinse, wipe and then
hang to dry naturally. Contact KStrong for any further questions.
• Additional maintenance and servicing procedure must be completed by authorized service center only.
• Store the SRL in a cool dry clean environment away from direct sunlight. Avoid areas where there may be the presence of chemical
vapors,heat,excessivemoisture,oilorotherdegradingelements.Soiled,wetorcontaminatedSRL’sshouldrstbethoroughly
cleaned and dried, before placing them in storage.
Structural Anchor (I-beam)
Snap Hook
Shock Pack
To this eye hole, attach
carabiner to applicable
harness
Bekijk gratis de handleiding van KStrong UFS310030, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | KStrong |
| Model | UFS310030 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4927 MB |
