KStrong UFS310010 handleiding
Handleiding
Je bekijkt pagina 7 van 28
7
9. CONNECTING SUBSYSTEMS
Use only those subsystems (full body harnesses, lanyard, rope grab and lifeline, cable sleeves) that are suitable for your application. See
subsystems manufacturer’s instructions for more information. A full body harness must be worn when using the equipment mentioned
in this manual. As per OSHA, the free fall distance should be limited to less than 6 ft., when the personal fall arrest system is used.
Additionally, the fall arrest force also should be less than 1800 lbs.(8 kN). Ensure the carabiner cannot cross-gate load (load against the
gate rather than along the backbone of the carabiner).
10. RESCUE PLAN
A rescue plan should be well documented and in place before performing work at height. The rescue operation must be performed by
trained and competent personnel only. The rescue expert team should supervise the rescue operation performed. It is also advised to
work in pairs while working on the site.
WARNING
If the equipment has been subjected to forces of fall arrest, in the event of a fall, then the equipment should be immediately removed from
service. Contact KStrong regarding any questions related to this.
11. ENVIRONMENTAL HAZARDS
It is important to take additional precautions while using this equipment in the presence of any environmental hazard so as to prevent
injury to the user or damage to the equipment.
• Environmental Hazards may include the following, but are not limited to:
• Chemicals
• Extreme Temperatures
• Corrosive Environments
• Gases
• HighVoltagePowerLines-ThereisapossibilityofanelectriccurrenttoowthroughthelifelineoftheSRL’s.Moistureabsorbed
bythelifelinemayalsocausetheelectriccurrenttoowthroughthelifeline.Useextremecautionwhenworkingnearsuchlines.
• Sharp Edges
• Moving Machinery and Vehicles
Please contact Kstrong with any questions regarding the use of this equipment in the presence of any environmental hazard.
WARNING
This equipment is not designed to be used in high temperature environments. It is important to protect this equipment when using near activities
like welding or metal cutting. Hot sparks may cause damage to this equipment or burn it. Contact KStrong for details on use of this equipment
in high temperature environments.
If the connecting element to which a snap hook (shown) or carabiner attaches is undersized or irregular in shape, a situation
could occur where the connecting element applies a force to the gate of the snap hook or carabiner. This force may cause the
gate (of either a self-locking or a non-locking snap hook) to open, allowing the snap hook or carabiner to disengage from the
connecting point.
Small ring or other non-compatibly shaped element
2. The gate presses
against the
connecting Ring.
3. The gate opens
allowing the snap
hook to slip off.
1. Force is
applied to the snap
hook.
Bekijk gratis de handleiding van KStrong UFS310010, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | KStrong |
| Model | UFS310010 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4927 MB |
