KStrong UFL201101 handleiding
Handleiding
Je bekijkt pagina 7 van 12
7
Calculating Total Fall Distances:
Total Fall Clearance below worker is calculated from
Anchorage Connection. Free Fall Distance + Energy
Absorber Deceleration Distance + Worker height + Safety
Factor. Care must be taken to ensure that the total fall
distance is clear of obstructions; such as equipment, to
avoid contact with a lower level.
Free Fall Distance + Energy Absorber Deceleration
Distance + Worker height + Safety Factor = 19 ft. (5.8 m)
Free Fall Distance + Energy Absorber Deceleration
Distance + Worker height + Safety Factor = 20 ft. (6.1 m)
This Application
requires a special
EA lanyard
Total 19 ft.
from Anchorage
6 ft. free Fall
Before
After
3 ft. Safety Factor
6 ft. Length of Energy Absorbing Lanyard
4 ft. Deceleration Distance
6 ft. Height of Worker
Anchorage
12 ft Free Fall
Total 20 ft.
from Anchorage
Before
After
Anchorage
3 ft. Safety Factor
6 ft. Length of Energy Absorbing Lanyard
5 ft. Deceleration Distance
6 ft. Height of Worker
• Swing Falls: Swing fall occurs when the position of the anchorage point is not directly above the point where a fall occurs. In such
a case if a fall were to occur, it will result in pendulum swing of the fall victim and may also cause them to strike nearby objects with
a force. This may cause serious injury or even death. Such swing falls may be minimized by ensuring that the anchorage is directly
overhead, and by working as close to the anchorage point as possible. Swing falls will substantially increase the fall clearance
required when a SRL or other variable length connecting subsystem is used.
• Extended Suspension: Using a full body harness: A FBH is not intended for use in extended suspension applications. If the user
is going to be suspended for an extended length of time, it is recommended that some form of a seat support be used. KStrong
recommends a seat board, suspension work seat, seat sling, or a boatswain chair. Contact KStrong for more information on these
items.
• Periodic Examination: Always keep the instructions provided with the product. Take the information from the markings on the
product and enter this information in the identication sheet. To ensure the safety of the user, it is essential to check the condition of
the equipment through periodic examinations of the product. This equipment must be examined by a qualied person at least once
in a six months, strictly complying with the manufacturer’s instructions. Also, record the previous check on the attached sheet. If the
equipment is in heavy usage or is used in a harsh environment, then the frequency of inspection should be increased in accordance
with regulations. Also check that the markings on the product are legible.
Illustration of Lanyard
Energy Absorber
- Inspection/ID Label
- Warning/Instruction Label
- Standards Label
Polyester Webbing
Steel Scaffold Hook
Steel Snap Hook
Bekijk gratis de handleiding van KStrong UFL201101, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | KStrong |
| Model | UFL201101 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1674 MB |
