KStrong UFL201101 handleiding
Handleiding
Je bekijkt pagina 10 van 12
10
LANYARD KEEPER
• When not in use, unused lanyard legs that are still
attached to a full body harness D-ring should not be
attached to a work positioning element or any other
structural element on the full body harness unless
deemed acceptable by the competent person. This is
especially important when using some types of “Y” style
lanyards, as some load may be transmitted to the user
through the unused lanyard leg if it is not able to release
from the harness. KStrong harnesses come with lanyard
keepers located at the sternal area, specially meant for
parking the unused leg of the lanyard. These also reduce
tripping and entanglement hazards of the lanyard.
HOW TO USE A TIE-BACK LANYARD
• Regular lanyards should not be used for tie back. Use
only KStrong lanyards (Models: UFL201402 and UFL201422) which are specically meant for tie-back usage. The snap hook at the
energy absorber end must be connected to the dorsal D-ring of the user’s full body harness. To ensure that the lanyard is properly
tied back, make sure to adjust the lanyard as per the diameter of the anchorage, and connect the tie-back snap hook to the D-ring
on the lanyard. Ensure that the lanyard is tightly cinched around the anchorage during use.
ADDITIONAL INFORMATION FOR ENERGY ABSORBING LANYARDS
• Training: It is essential that the users of this type of equipment receive proper training and instructions, including detailed procedures
for the safe use of such equipment in their work application. ANSI/ASSE Z359.2, minimum requirements for a comprehensive
managed fall protection program, establishes guidelines and requirements for an employer’s managed fall protection program.
These include policies, duties and training, fall protection procedures, eliminating and controlling fall hazards, rescue procedures,
incident investigations, and evaluating program effectiveness.
• KStrong energy absorbing lanyards meet ANSI/ASSE Z359.13 and are intended to be used with other components of a PFAS and
limit maximum arrest forces to 1800 lbs. (8 kN) or less.
MAINTENANCE, SERVICE AND STORAGE
• KStrong energy absorbing lanyards can be cleaned with water and a mild soap solution. However, if a lanyard is excessively dirty,
or there is a build-up of material like paint, etc., then this may hamper the lanyard from functioning properly. In severe cases, the
webbing may be degraded to a point where it weakens. In such a case, remove the lanyard from service.
• Never use bleach or bleach solutions to clean the lanyard as this may damage the webbing. Always dry the lanyard by hanging to
air dry. Do not force dry with heat. The hardware should be wiped off with a clean dry cloth. Contact KStrong with any questions.
• Additional maintenance and servicing procedures must be completed by an authorized service center.
• Store the energy absorbing lanyards in a cool dry clean environment, away from direct sunlight. Avoid areas where they may be in
the presence of chemical vapors, heat, excessive moisture, oil or other degrading elements. It is extremely important to thoroughly
inspect the lanyards after extended storage.
• Equipment in need of or scheduled for maintenance, must be tagged as “unsuitable” and removed from service.
NOTE
• Do not attempt to disassemble the unit or make repairs to the equipment. Send the equipment back to the manufacturer, or persons
or entities authorized in writing by the manufacturer to make repairs to the equipment.
Lanyard Keeper
Bekijk gratis de handleiding van KStrong UFL201101, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | KStrong |
| Model | UFL201101 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1674 MB |
