Krowne BC24 handleiding

28 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 24 van 28
24 Krowne • 100 Haul Rd. Wayne, NJ 07470 • krowne.com
Refrigeration Installation & Operating Manual
1. Cut out 3-3/4” holes in the counter top for the beer lines and 1-1/2” holes for the drip pan drain. Use the supplied drain
pan as a guide for hole locations.
2. Attach 1” tall square bracket to the countertop based on your application.
3. Cut black 4” round foam tube to length to insulate the area between the unit and the mounting bracket (through
countertop).
4. Attach gray hose to white 1” barb that is mounted inside the unit and up out of the countertop. Cut gray air hose to
required length – For 1 to 3 taps, the hose should be about 75% up into the tower. For 4 to 8 taps, the hose should be just
inside the “box” of taps.
5. Apply a small amount of silicone to at mating surface on the underside of pan to ensure no liquid gets between drain pan
and stainless top. This also results in better insulation. Set drain pan over the square bracket and align the four holes as
best as possible.
6. Feed the beer lines from the tower to the larger hole around the gray air hose.
7. Thread the attached straight 1/2” barb onto the drain that may still need to be mounted to the drain pan with silicone.
Tighten the supplied nut on the under side of the pan.
8. Cut the supplied clear drain hose to length to get it as close as possible to the top of the body to eliminate liquid traps in
the drain line.
9. Inside the unit, attach the 90° white 1/2” elbow to the drain line that is already installed in the unit.
10. Place the tower over the pan and apply the rubber gasket and (4) 10-32 counter sunk screws (screws are supplied).
Tools Required: Phillips Head Screwdriver, Silicone, & Mounting
Hardware according to Countertop
Installing Dispensing Towers
1” GREY AIR HOSE
CLEAR 1/2”
DRAIN HOSE
STONE OR WOOD
COUNTERTOP
SCREWS BASED
ON APPLICATION (8)
ARMAFLEX 3-1/8” OD X 3/8”
WALL X 6’ FLEXIBLE BLACK
TUBE INSULATION
5” X 5” X 1”
#10-32X.75
SS FLAT HEAD
SCREWS (4)
APPLY A GOOD BEAD
OF SILICONE UNDER THE DRIP TRAY
ALL THE WAY AROUND
1” DRAIN

Bekijk gratis de handleiding van Krowne BC24, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkKrowne
ModelBC24
CategorieKoelkast
TaalNederlands
Grootte13211 MB