Kress Marconi handleiding
Handleiding
Je bekijkt pagina 7 van 24
7
En
Assembly
WARNING: Before assembly, make sure machine is turned off.
The installation of node
1. Connect the node with the wire (Fig. A)
2. Install node
Note: Please open the cover of machine before operation
Put node into the slot as picture has showed. (Fig. B).
3. Connect wire with the board (Fig. C1, C2).
1) As picture has showed, connect end of the wire with the mainboard.
2) Organize the wire and then put the mainboard into the mainboard slot, and x it with the pressure plates and
screws(come with the machine).
3) Close the cover to complete the operation.
The installation of gateway at home
1. Assemble the AC adapter and cable (for AC adapter) to power the gateway. A few seconds later, the indicator
of network,gateway/node and power will individually turn red, green and blue .Use the cable (for gateway) to
connect your router and gateway (Fig. D). The network indicator will turn green in 10 seconds. At this time , the
three lights will be red ,green and blue from left to right. (Fig. E)
2. Employ the sharp object to press the reset button. Then the lights separately turn multi-colors. (Fig. F, G)
The connection between gateway and mower
1) For LED display
Turn your lawn mower on then input the correct PIN code of user. Press for three seconds. Then press and
“
nrc” will be displayed on the screen. Afterwards press . (Fig. H, I).The screen will display the interface , as gure
J has showed and the lights on gateway all turn green after about one minute which means that the gateway and
lawn mower have been connected successfully (Fig. K).
2) For LCD display
Turn your lawn mower on then input the correct PIN code of user. Choose and press . Then select “Setup
Marconi”, press to conrm. Then screen will display “Press “OK”
to start pairing Marconi - Gateway” ,press
to conrm. Finally, the screen displays “Pairing successful!” and the lights on gateway turn green which means the
gateway and lawn mower have been connected successfully (Fig. L, M, N, O, P)
Troubleshooting
Make sure your Marconi module is securely installed and follow the actions below if your Marconi does not operate
correctly.
If these do not identify and correct the problem, contact your dealer.
Symptom Cause Action
Network indicator on
gateway turns red
The cable is not connected
properly.
Make sure it is properly connected on both
sides.
The indicator of Gateway /
node turns red
the lawn mower is not turned on or
the module is not properly plugged.
Turn the lawn mower on or plug the module
properly.
Lawn mower and gateway are not
paired correctly.
Make sure Gateway and lawn mower are
paired correctly.
Power indicator turns
red
Gateway is not connected to the
network.
Under the premise of tight connection
between router and Internet, make sure the
gateway is connected with router normally.
Note: if despite acting as above the machine still not work properly, you should try to re start it and re-pair following
manual instruction
Bekijk gratis de handleiding van Kress Marconi, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Kress |
| Model | Marconi |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2622 MB |
