Handleiding
Je bekijkt pagina 44 van 64
44
Self-Clean Function
• To active this function, turn off the indoor unit, then press both ‘SWING’ buttons at the
same time while pointing towards the indoor unit until you hear a beep. ‘AC’ will appear
on the remote control display and the indoor LED display.
• This function helps remove accumulated dirt, bacteria, and other contaminants from
the indoor evaporator.
• This function will run for approximately 30 minutes and then return to the pre-set mode.
You can press the Power button to cancel this function during the process.
• You will hear 2 beeps when it is finished or cancelled.
Warning
• It is normal to hear some noise during this process, as plastic materials expand with
heat and contract with cold.
• It is recommended to use this function under the specific ambient conditions outlined in
the table below to avoid triggering certain safety protection features.
• It is recommended to use this function every three months.
Indoor unit Temp < 86°F (30°C)
Outdoor unit 41°F (5°C) < Temp < 86°F (30°C)
Operating Environment
Using the air conditioner outside the specified temperature range may activate its
protection device and cause it to fail to operate. Therefore, it is recommended to use the air
conditioner within the following temperature conditions.
Fixed air conditioner:
MODE
Heating Cooling Dry
Temperature
Room temperature 0°C~27°C (32°F~80°F) 17°C~32°C (63°F~90°F)
Outdoor
temperature
-7°C~24°C (19°F~75°F)
T1 climate: 15°C~43°C
(59°F~109°F)
T3 climate: 15°C~52°C
(59°F~125°F)
Bekijk gratis de handleiding van Kogan KASHSAC26TA, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Kogan |
| Model | KASHSAC26TA |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 5814 MB |
