Handleiding
Je bekijkt pagina 14 van 32
Cool mode
• After being powered and turned on to cool mode, the cool mode indicator light will
come on.
• Press the UP or DOWN button to adjust the desired temperature (17°C – 30°C).
• Press the SPEED button to select high, medium or low speed.
Fan mode
• Press the MODE button to select fan mode, and the fan indicator light will
illuminate.
• Press the SPEED button to select high, medium or low air speed. The temperature
cannot be set in this mode.
Dry mode
• Select dry mode by pressing the MODE button, and the dry indicator light will
illuminate.
• As shown in the picture below, remove the plug from the water drainage outlet and
insert a drainage hose (not included). Put the other end of the hose into a container
or into a drain.
• When entering the dry mode, if the room temperature is higher than 15°C, the
compressor will start to work. When the room temperature drops below 13°C, the
compressor will stop. If the room temperature rises up above 15°C again, the
compressor will restart (the restarting of the compressor will be limited by the 3-
minute delay protection function).
• In dry mode, the fan will run in low speed by default, and the airspeed is not
adjustable.
• Temperature cannot be set.
OPERATION
Note:
It is recommended to remove the exhaust air hose in dehumidification mode.
Otherwise, dehumidification may not work properly or the full water tank (“FL") alarm
will flash on the display.
Bekijk gratis de handleiding van Kogan KAPRA14WFGA, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Kogan |
| Model | KAPRA14WFGA |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 3872 MB |
