Kiloview RN-40 handleiding
Handleiding
Je bekijkt pagina 13 van 32
Copyright © Changsha KILOVIEW Electronics CO.,LTD. All rights reserved
N40 for NDI·USER MANUAL V2.0
11
5 Login and Network Configuration
5.1 Login to the Device via Ethernet
First connect the Ethernet port of the NDI encoder and the computer to the same switch, or
connect the encoder directly to the computer network port. Then configure the encoder and
computer to the same network segment so that the computer can access to the web page of
the encoder.
The default management IP address of the encoder is 192.168.1.168.（This is the failsafe
address of the device. Generally, do not modify this IP address.）If the IP address of the
computer is not in the segment of 192.168.1.*, please set the IP address of the computer
network port to 192.168.1.*.
Open the WEB browser, directly input the IP address of the encoder (default is
192.168.1.168) or the URL http://192.168.1.168 and press Enter to open the login interface.
After opening the page, an authentication dialog will pop up, please fill in the username and
password, the default username is admin, the default password is admin, and then click
"Login".
Note: Due to the browser compatibility issues, it may cause the web page display abnormal, it
is recommended to use Chrome or Firefox.
For the first login or the first login after restoring the factory settings, you will need to agree to the
“EULA” that pops up. Otherwise, the NDI stream service cannot be used normally.
After login, the encoding and function parameters can be set on the encoder management
web page. The page is shown as below:
Bekijk gratis de handleiding van Kiloview RN-40, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Kiloview |
| Model | RN-40 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6742 MB |
