Kiloview N60 handleiding
Handleiding
Je bekijkt pagina 20 van 47
N60 for NDI·USER MANUAL V1.6
Copyright © Changsha KILOVIEW Electronics CO.,LTD. All rights reserved
19
6 Login and Network Configuration
6.1 Login to the Device via Ethernet
First connect the Ethernet port of the NDI encoder and the computer to the same switch. After powered
on, you can turn the wheel knob to switch the screen to view the network port you are currently
connected to, such as "ETHERNET 1" (NETWORK 1) or "ETHERNET 2" (NETWORK 2). IP address can be
also shown on the page.
Open the WEB browser, directly input the IP address to login. The default
username and password are admin/admin.
Note: Due to the browser compatibility issues, it is recommended to use Chrome or Firefox. For the first login after restoring
the factory settings, you will need to agree to the “EULA” that pops up. Otherwise, the NDI stream service cannot be used normally.
After login, the encoding and function parameters can be set on the encoder management web page.
The page is shown as below:
6.2 Network Settings
Connect the network cable to the Ethernet port and configure with an IP address. The IP address of the
network port is obtained by DHCP by default, which will automatically get a full IP address, gateway and
DNS based on this LAN.
The N60 has two Gigabit network ports, of which Network 1 supports POE. Here take Network 1 as an
example.
Click “Network” to check the configuration of the Ethernet.
Bekijk gratis de handleiding van Kiloview N60, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Kiloview |
| Model | N60 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 12443 MB |
