Kichler Ferron handleiding
Handleiding
Je bekijkt pagina 11 van 15
10
Fig. 19
Fig. 20
Blue Light
Ferron
TM
Press/hold Button
3. Test the transmitter by pushing and releasing
ANY button briefly. A Blue Light should illuminate
under the 3-4 buttons. (Fig. 19) If not, check to
make sure the batteries are inserted and seated
correctly.
Power Up and Programming:
4. Follow the below steps to set the remote control:
The auto learning function will only mandate within
60 seconds when turning the fan’s AC power ON.
(Figure 20)
5. Select desired frequency from the back of
transmitter.
6. From the back of the transmitter, press the “ ”
button, and hold the “ ” button for over 5
seconds. Once the receiver has detected the
frequency, the light will flash twice, and the fan will
automatically begin to operate and start to rotate in
the counter clockwise direction and on the highest
RPM for 3 minutes. When counterclockwise
rotation has finished, the fan will automatically
reverse to clockwise direction again to the highest
RPM for 3 minutes. Fan will shut off when the self
calibration test has finished. The total self
calibration test will last about 6 minutes.
NOTE: If the self calibration test failed, turn the AC
power off; restore power and process the self
calibration test again.
NOTE: During self calibration test, the remote is
non-fuctional.
NOTE: The learning frequency function and self
calibration test will continue to retain the last set
frequency and calibration set even when the AC
power is shut off. If the frequency is changed the
self calibration test will occur again.
7. Your CoolTouch™ Control System is now
programmed and ready for use. Please see the
follow Operational Instructions.
The receiver provides the following protective
function:
1. Lock position: The DC motor has a built-in safety
against obstruction during operation. If there is an
obstruction, the motor will stop and then the power
will automatically go off in 30 seconds. Remove the
obstruction and reset.
2. Over 80W protection: When the receiver detects
motor power consumption which is greater than
80W, the receiver power will be stopped and
operation will immediately discontinue. Wait for 5
seconds and then turn the receiver power back on.
Bekijk gratis de handleiding van Kichler Ferron, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Kichler |
| Model | Ferron |
| Categorie | Ventilator |
| Taal | Nederlands |
| Grootte | 4162 MB |
