Handleiding
Je bekijkt pagina 7 van 90
Important Safety
Instructions
Operation of Current Device
(Applicable to the unit adopts current detection device only )
Note: Performance may be reduced
outside of these operating
temperatures.
NOTE:
Do not use this device to turn the unit on or off.
Always make sure the RESET button is pushed in for correct operation.
The power supply must be replaced if it fails reset when either the TEST button is
pushed, or it cannot be reset. A new one can be obtained from the product manufacturer.
If power supply cord is damaged, it cannot be repaired. It MUST be replaced by one
obtained from the product manufacturer.
NOTE:This air conditioner is designed to be operated under condition as follows:
Page 6
Cooling
operation
Outdoor temp:
Indoor temp:
Heating
operation
Outdoor temp:
23-76°F/-5-24°C
Indoor temp:
32-80°F/0-27°C
64-109°F/18-43°C (64-125°F/18-52°C
for special tropical models)
62-90°F/17-32°C
Do not use an extension cord or an adapter plug.
mechanical damage within the air conditioner.
Do not run air conditioner without side protective cover in place.This could result in
the receptacle is accessible after the unit installation.
fuse or circuit breaker, have a qualified electrician install the proper receptacle. Ensure
receptacle you intend to use is not adequately grounded or protected by a time delay
Your air conditioner must be used in a properly grounded wall receptacle. If the wall
grounding plug for protection against shock hazards.
proper grounding is important. The power cord is equipped with a three-prong
Be sure the air conditioner is properly grounded. To minimize shock and fire hazards,
plate. Refer to the rating when checking the electrical requirements.
The complete elect
r
ical
rating of your new room air conditioner is stated on the serial
Electrical Information
avoid cuts from sharp metal fins on front and rear coils.
removing or installing this unit. When handling the air conditioner, be careful to
installation instructions in this manual. Save this manual for possible future use in
Be sure the air conditioner has been securely and correctly installed according to the
it also indicated by a light on the plug head.)
4. The power supply cord is now supplying electricity to the unit. (On some products this
3. Press the RESET button, again you will notice a click as the button engages.
button, you will notice a click as the RESET button pops out.
2. The power supply cord will have TWO buttons on the plug head. Press the TEST
1. Plug in the Air Conditioner.
To test your power supply cord do the following:
The power supply cord contains a current device that senses damage to the power cord.
Bekijk gratis de handleiding van Keystone KSTAW08CE, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Keystone |
| Model | KSTAW08CE |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 15608 MB |
