Handleiding
Je bekijkt pagina 20 van 90
Installation
Instructions
Page 19
or
Measure the inner width
of the side curtain
1 2 3 4 5 6 7 8
9 10 11 12 13 14 15 16 17
1 2 3 4 5 6
1. Lift air conditioner and carefully slide into
cabinet leaving 6 inches protruding.
2. DO NOT push on controls or finned coils.
3. Be sure chassis is firmly seated towards rear of
cabinet.
4. Installation of front is the reverse of removal
outlined in Section 1.
In order to minimize air leaks and ensure optimal
insulation, it is necessary to install the included R1
hardware to the side curtain. Follow the
instructions below.
Step 1. After the unit is installed to the window,
measure the inner width of the side curtain as
shown (Fig.20).
Step 2. Remark a line on the provided R1
insulation panel according to a length 1/8 "
(3mm) less than the measured width in step 1,
then cut the R1 insulation panel along the line
(Fig. 12).
Step 3. Slide the R1 insulation panel into the
side curtain, the side with pattern should facing
the indoor (Fig. 22).
In order to minimize air leaks between the room
air conditoner and the window opening, trim the
weather stripping with a proper length, peel off
the protective backing and plug any gaps if
needed (Fig.23).
Step 4. Repeat on the other side.
9
Install Chassis into Cabinet and Install
Front to Unit
10
11
Fig.20
Fig.21
Fig.22
Fig.23
to ≥15000Btu/h models )
Install R1 HARDWARE (only applicable
Install WEATHER STRIPPING
Bekijk gratis de handleiding van Keystone KSTAW08CE, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Keystone |
| Model | KSTAW08CE |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 15608 MB |
