Handleiding
Je bekijkt pagina 38 van 40
38
BEFORE YOU INSTALL THE HOB, MAKE SURE THAT
•
the work surface is square and level, and no structural members interfere with space requirements
• the work surface is made of a heat-resistant material
• if the hob is installed above an oven, the oven has a built-in cooling fan
•
the installation will comply with all clearance requirements and applicable standards and
regulations
•
a suitable isolating switch providing full disconnection from the mains power supply is
incorporated in the permanent wiring, mounted and positioned to comply with the local wiring
rules and regulations.
The isolationg switch must be of an approved type and provide a 3 mm air gap contact
separation in all poles (or in all active [phase] conductors if the local wiring rules allow for this
variation of the requirements)
• the isolating switch will be easily accessible to the customer with the hob installed
• you consult local building authorities and by-laws if in doubt regarding installation
• you use hest-resistant and easy-to-clean finishes (such as ceramic tiles) for the wall surfaces
surrounding the hob.
WHEN YOU HAVE INSTALLED THE HOB, MAKE SURE THAT
• the power supply cable is not accessible through cupboard doors or drawers
• there is adequate flow of fresh air from outside the cabinetry to the base of the hob
• if the hob is installed above a drawer or cupboard space, a thermal protection barrier is installed
below the base of the hob
• the isolating switch is easily accessible by the customer
CAUTIONS
1.
The industion hotplate must be installed by qualified personnel or technicians. We have
professionals at your service. Please never conduct the operation by yourself.
2. The hob will not be installed directly above a dishwasher, fridge, freezer, washing machine or
clothes dryer, as the humidity may damage the hob electronics.
3.
The induction hotplate shall be installed such that better heat radiation can be ensured to enhance
its reliability.
4. The wall and induced heating zone above the table surface shall withstand heat.
5. To avoid any damage, the sandwich layer and adhesive must be resistant to heat.
ATTENTION
Check with an electrician whether the domestic wiring system is suitable without alterations.
Any alterations must only be made by a qualified electrician.
CONNECTING THE HOB TO THE MAINS POWER SUPPLY
ATTENTION
This hob must be connected to the mains power supply only by a suitably qualified person.
Before connecting the hob to the mains power supply, check that:
1. the domestic wiring system is suitable for the power drawn by the hob
2. the voltage corresponds to the value given in the rating plate
3. the power supply cable sections can withstand the load specified on the rating plate.
To connect the hob to the mains power supply, do not use adapters, reducers, or branching
devices, as they can cause overheating and fire.
The power supply cable must not touch any hot parts and must be positioned so that its
temperature will not exceed 75ºC at any point.
Bekijk gratis de handleiding van Kernau KIH 3212-2B, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Kernau |
| Model | KIH 3212-2B |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 4200 MB |
