Kernau KFWM 8423.1 IR D Steam handleiding
Handleiding
Je bekijkt pagina 78 van 164
78
FAULT POSSIBLE CAUSE
TROUBLESHOOTING
Unsatisfactory washing
result.
Your washing is too dirty for the
programme selected.
Use the information in the
programme tables to select the most
appropriate programme.
Amount of detergent used
insufficient.
Use the amount of detergent as
instructed on the packaging.
There is too much laundry in
your machine.
Check that the maximum capacity
for the selected programme has not
been exceeded.
Unsatisfactory washing
result.
Hard water.
Increase the amount of detergent
following the manufacturer’s
instructions.
Your laundry is too tightly
packed together in the drum.
Check that your laundry is spread
out.
As soon as the machine is
loaded with water, water
discharges.
The end of water drain hose is
too low for the machine.
Check that the drain hose is at a
suitable height. (**) .
No water appears in the
drum during washing.
No fault. Water is in the unseen
part of the drum.
Laundry has detergent
residue.
Non-dissolving particles of
some detergents may appear on
your laundry as white spots.
Perform an extra rinse, or clean
your laundry with a brush after it
dries.
Grey spots appear on the
laundry.
There is untreated oil, cream or
ointment on your laundry.
Use the amount of detergent as
instructed on the packaging in the
next wash.
The spin cycle does not take
place or takes place later
than expected.
No fault. The Unbalanced load
control system has been
activated.
The Unbalanced load control
system will try to spread your
laundry. The spinning cycle will
begin once your laundry is spread.
Load the drum evenly for the next
wash.
(*) See the chapter regarding maintenance and cleaning of your machine.
(**) See the chapter regarding installation of your machine.
CHAPTER 10. AUTOMATIC FAULT WARNINGS AND WHAT TO DO
Your Washing Machine is equipped with a built-in fault detection system, indicated by a combination of
flashing wash operation lights. The most common failure codes are shown below.
TROUBLE CODE POSSIBLE FAULT WHAT TO DO
Er 01
The door of your machine is not
shut properly.
Shut the door properly until you
hear a click. If your machine
persists to indicate fault, turn off
your machine, unplug it and
contact the nearest authorised
service agent immediately.
TROUBLE CODE POSSIBLE FAULT WHAT TO DO
Er 02
The water pressure or the water
level inside the machine may
be low.
Check the tap is fully turned on.
Mains water may be cut-off. If
the problem still continues, your
machine will stop after a while
automatically. Unplug the
machine, turn off your tap and
contact the nearest authorised
service agent.
Er 03
The pump is faulty or pump
filter is clogged or electrical
connection of the pump is faulty.
Clean the pump filter.
If the problem persists,
contact the nearest authorised
service agent (*)
Er 04
Your machine has excessive
amount of water.
Your machine will discharge
water by itself. Once the water
has drained, turn off your
machine and unplug it. Turn off
the tap and contact the nearest
authorised service agent..
Bekijk gratis de handleiding van Kernau KFWM 8423.1 IR D Steam, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Kernau |
| Model | KFWM 8423.1 IR D Steam |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 17421 MB |
