Kernau KDI 4753 SAD handleiding
Handleiding
Je bekijkt pagina 50 van 68
50
Level Brightener Dose Indicator
1 Rinse-aid not dispensed
r:1 is shown on the
display
2 1 dose is dispensed
r:2 is shown on the
display
3 2 doses are dispensed
r:3 is shown on the
display
4 3 doses are dispensed
r:4 is shown on the
display
5 4 doses are dispensed
r:5 is shown on the
display
USING COMBINED DETERGENTS
These products should be used according to the manufacturer’s instructions. Never put combined detergents
into the interior section or the cutlery basket.
Combined detergents contain not only the detergent but also rinse-aid, salt replacement substances and
additional components depending on the combination. We recommend you do not use combined detergents
in short programmes. Please use powder detergents in such programmes.
If you encounter problems when using combined detergents, please contact the detergent manufacturer.
When you stop using combined detergents, make sure that water hardness and rinse aid settings are set to
the correct level.
RINSE-AID USAGE
The rinse aid helps to dry the dishes without streaks and stains. Rinse-aid is required for stain-free utensils
and clear glasses. The rinse aid is automatically released during the hot rinse phase. If rinse aid dosage setting
set too low, whitish stains remains on dishes and dishes do not dry and washed clean. If rinse aid dosage
setting set too height, you can see bluish layers on glass and dishes.
FILLING THE RINSE-AID AND SETTING
To fill the rinse aid compartment, open the rinse-aid compartment cap. Fill the compartment with rinse aid
to the MAX level and then close the cap. Be careful not to overfill the rinse aid compartment and wipe up
any spills.
In order to change the rinse aid level, follow the below steps
• Turn on the machine and press Menu button for 3 seconds. Water hardness level is seen first.
(“SL3” is the factory setting)
• Press Delay(+) button to pass Rinse aid setting. (“r:4” is the factory setting)
• Rinse aid setting follows water hardness setting.
• Then, press Select button and the level of Rinse aid (e.g. “r:4”) blinks.
• Change the level by pressing the Delay button.
•
Press Select button to save desired level and the new level of Rinse aid will illuminate constantly.
• Turn off the machine to exit from the setting.
The factory setting is “4”.
If the dishes are not drying properly or are spotted, increase the level. If blue stains form on your dishes,
decrease the level.
Bekijk gratis de handleiding van Kernau KDI 4753 SAD, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Kernau |
| Model | KDI 4753 SAD |
| Categorie | Vaatwasser |
| Taal | Nederlands |
| Grootte | 8636 MB |
