Handleiding
Je bekijkt pagina 18 van 158
Troubleshooting Guide
Problem Cause Solution
Smooth or Chunky Soup
programme in the keep
warm mode.
Normal Function.
To stop the Keep Warm mode turn
the dial to '0' position.
'End' shown and
flashing on screen.
Unit beeping.
Cold blending cycle
reached 3 minutes
and unit automatically
stopped.
To reselect the speed press 'Start'
or to stop turn the dial to 'O'.
It is recommended to allow the
blender to cool down for 15 minutes
if you want to operate for more
than 3 minutes at a time.
Preset finished or
cancelled.
Turn the dial to 'O' or press 'Start' to
reselect a preset.
'----' shown on
screen.
Standby mode. Normal operation.
Select speed or preset.
'OPEN' shown and
flashing on screen.
Unit beeping.
Lid not fitted.
Fit lid and press 'Start'.
Lid removed or open
during processing.
'JUG' shown and
flashing on screen.
Unit beeping.
Goblet not fitted.
Fit goblet and press 'Start'.
Goblet removed during
processing.
Error Codes
E0 - E5 shown on
screen and unit
beeps.
Heater or motor
overload/overheat issues.
(Thermal cut out
operated).
Unplug and wait a few seconds until
the screen goes blank.
Then plug back in to reset.
Before restarting check that
sufficient liquid is being used.
Insufficient liquid in
recipe and goblet has
boiled dry.
Goblet overloaded.
Check that sufficient liquid added.
Follow the advice in this manual
and reduce processing quantities if
exceeding the recommendations.
If the problem persists contact your nearest authorised Kenwood Service Centre.
To find up to date details of your nearest Kenwood Service Centre visit
www.kenwoodworld.com or the website specific to your country.
12
Bekijk gratis de handleiding van Kenwood SoupEasy+ CBL30, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Kenwood |
| Model | SoupEasy+ CBL30 |
| Categorie | Blender |
| Taal | Nederlands |
| Grootte | 13363 MB |