Kenwood KSC-256A handleiding
Handleiding
Je bekijkt pagina 6 van 28
4
CHARGING PROCEDURE
Do not use in explosive atmospheres (gases, dust, fumes, etc.).
ATTENTION: Always switch OFF a transceiver equipped with a battery pack before inserting the
transceiver into the charger.
1 Ensure that the Power switch is in the off (
) position. Plug the AC cord into the AC inlet located on
the rear of the charger.
2 Plug the AC plug into an AC outlet.
3 Press the Power switch to turn the charger ON.
4 Slide a battery pack or a transceiver equipped with a battery pack into the charging slot.
• The indicator lights red and charging starts.
• Make sure the metal contacts of the battery pack mate securely with the charger terminals.
5 When charging is completed, the indicator flashing green. Remove the battery pack or the transceiver
from the charging slot and turn the power off.
• When the charger will not be used for a long time, unplug the AC cord from the AC outlet.
To
AC outlet
Power switch
AC cord
E type
T type
E type : For Europe
T type : For UK
CHARGER STATUS TABLE
Indicator Color Meaning
Red
A battery pack or a transceiver equipped with a battery pack is in the charging slot and
charging has started.
TheLEDwillashingRed
or will not light
The battery pack is defective or the battery pack contacts are not properly mated with
those of the charger.
Alternatesashinggreen
and orange
Thetemperatureofthebatterypackhasnotsatisedthechargingstarttemperature.In
this instance, remove the battery until its temperature increases, then recharge it.
Flashing Green Charging is completed; remove the battery pack or the transceiver from the charging slot.
Bekijk gratis de handleiding van Kenwood KSC-256A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Kenwood |
| Model | KSC-256A |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3033 MB |
